Accessport not communicating

[sk8erord]

So I flashed my car to stage one last week and it all seemed to go fine. Yesterday I hooked up the ap to monitor the gauges and after a minute it said shutting down because it detected the engine had turned off. I was still driving. Now when I plug out in it turns on and just sits at trying to connect to my vehicle.

The flash seemed successful. It said it was, I can switch map slots, and it said it's installed...

Sent from my HTC6525LVW using Tapatalk

Sponsored

 

[Ultimateone]

are you on the latest firmware? there was an update a few days ago

 

[sk8erord]

Hmm, my ap manager says the last update was 6/24 and that my AP is up to date.

 

[Saluki_stang]

There was an update 8/3 i believe

 

[sk8erord]

Yeah I turned on beta updates and one came down. Communicated until I went to gauges then went back to trying to communicate

Sent from my HTC6525LVW using Tapatalk

 

[sk8erord]

So interestingly enough - it seems one of the gauge settings is what's causing the problem. I connected the AP to my computer, and reset it to defaults, and it works again. The one I had selected when it "crashed" was the CAT V Sensor (I think). I was trying to monitor the charge air temps.

 

[MAPerformance]

So interestingly enough - it seems one of the gauge settings is what's causing the problem. I connected the AP to my computer, and reset it to defaults, and it works again. The one I had selected when it "crashed" was the CAT V Sensor (I think). I was trying to monitor the charge air temps.

Yea, that posed an issue on another customers car as well. You are just going to want to look at Charge Air Temperature, not the voltage!

Glad you got it sorted out!

Sponsored