Anyone with Stock paxton belt and 3.48 pulley

Is anyone running the stock paxton belt with the 3.48 pulley and what tensioner hole are you in? I have a Gates K061025 (6PK2601) V-Groove Belt belt I was planning to run with the 3.48 pulley and tensioner in the stock location. I am curious what works best for you guys. Also is there a optimum range of travel for the tensioner? Is it better to have a belt that barely fits?

Stock hole needs 101" belt for that pulley, maybe try just pulling it over to the holes closer to passenger side with that 102.5 belt

VRP said:

Stock hole needs 101" belt for that pulley, maybe try just pulling it over to the holes closer to passenger side with that 102.5 belt

Click to expand...

That is surprising since another member said he used it in the stock hole with that belt. I had another guy say you can run the stock belt if you move idler over one hole.

I moved my belt one hole over and used the stock belt but it was tight as hell and hard to get on there. It is now in the hole closest to the passenger side.

I moved one hole over and run the Gates 101. Seems to do the trick.

RubyRedBoost said:

I moved one hole over and run the Gates 101. Seems to do the trick.

Click to expand...

So you are in the center hole? Was it hard to get the belt on?

It was very difficult with the green belt. Had to walk it on