Search results

Soft reset is done while car is in aux mode by holding in the power button and the forward seek button at the same time for like 5 seconds. The system will reset but you won’t lose any of ur presets, phone connections, etc.

Good news- tested the soft reset and it seemed to work fine.

So I typically use CarPlay so I don’t ever really use the touch sync side of the touch screen but today I was noticing that when I would touch “audio” or any of the other icons there was a pretty lengthy delay. I’d say like 5 seconds or so. Anyone else run into this? Maybe like a hard restart to...

The steeda kit was the fix. After install and new alignment, looks perfect! Thanks everyone

I don’t even understand what is going on anymore. I got the Chance to wash and really get a good look at the car today and the passenger side front is about a half inch higher than the driver side front. Had the same shop do the work as my last mustang and never had problems. Complete flat driveway

is this something the alignment shop should take care of? Or the shop that did the lowering? My guess is they may have lowered the subframe to install the springs and it moved but I don’t know who fixes that

so is it the steeda kit or BMR? Or is the combo together is best?

thanks everyone- I was reading the directions and it says it needs an alignment after they’re installed so is it safe to say this alignment I just paid for was a waste? Lol

Here’s a copy of the alignment

this was the fix. Bought a used one off of eBay, installed with no issues…clear, and parking assist lines are there with no issues. Thanks all!

So I just got my car lowered on steeda progressives and put the 20mm spacers on the rear, 1” up front. I didn’t notice it til I got home that the rears are pretty different from the level of poke. I double checked to make sure that the rears were both 20mm. The car was also aligned. Any ideas...

My camera is shot on my 19 Bullitt. Super distorted . Tried everything to clean it and found a used on on eBay for $40 so I figured give it a shot. The only walk thrus I’ve seen on how to replace the camera is by watching the deck lid replacement. I’ve seen people say the camera needs...

Does anyone know the part number for rear view camera? I found one for like $300 and another for around $40? I was going to roll the dice on this one but it’s not oem. Not sure if anyone has any experience with replacing the camera but it seems rather straight forward...

Thanks! Do you know if this is part of a recall? The factory bumper to bumper expired this September. Just was wondering if I can lean on the local ford dealer? I reached out to the prior dealer in Kansas bc I’m pretty sure the state required a 30 day warranty on any car out of warranty but I...

i noticed with this "new used" bullitt i bought that i dont think that the rear view camera is as clear as it is in my explorer or even the previous bullitt i owned. maybe im just imagining things but it almost seems like theres a film over the lens or something...the image just isnt clear...

Hopefully the magneride versions go on sale too!!

car was cold. Hasn’t been driven for a few days

So…I picked up a used bullitt with 718 miles on it. Don’t kill me but I never noticed this til I got home, from a 700 mile drive that my coolant level was well below the minimum line. Is this something I should be really concerned with? I have to get the car registered/inspected in PA and I did...

I recently bought a used bullitt with 700 miles on it. Despite the condition of the car it looks as if the dealer polished it. Id like to give it a fresh start but where do I begin? iron remover then clay then polish then plan was to use cquartz slic. I’ve used car pros ceramic in the past and...

I had some chemical guys all clean and just sprayed it in and left it while I washed the wheels then went back with a soft brush and it came right off. Just looked like a sloppy job rather than something that was done a bunch of times.