Thanks for your reply.
I rang a couple of places today.
I've was told they were happy to do it as long as I could provide documentation that the Edelbrock kit was ADR legal. Unfortunately no such document exists.
Hello,
Hoping for advice/info.
I have 2017 Mustang GT with an Edelbrock supercharger.
I did the installation myself a few years back.
I have the car up for sale and was wondering what my options were for a RWC? I'm located in Victoria.
Or is it easier to return back to stock?
Thanks in...
Ok so I decided to re-log. I didn't really want to as I am too scared the engine is gonna blow.
Link below to datazap.
My issue is captured at 4000rpm. It's the only peak that goes that high.
I have some idle, rpm holds and then a relatively slow build up in third up to 4000rpm...
So I've had a look at the log again. I've attached a photo but it's not ideal or helpful.
Blue line is rpm (4400), speed around 56mph.
Right where I think my problem is, AFR1 0.84, AFR2 1.17, STFT1 1.03 and STFT2 1.25.....
There is a small amount of knock (0.25) just before or at it.
I...
Thanks for responding Cory.
I've had a look but I really don't understand what TQ Source means or pattern I'm looking for.
Over the whole datalog my max tq source is 22, min is 0 and average of 3.29.
I've just sent off a log to Lund. See what comes back.
The latest log I have is too large for a Datazap.
I can't upload .csv files here.
I managed to capture issue in the log.
I am not expert in reading them.
The knock sensor is pretty active but random.
No real knock where my issue...
Hello,
I'm hoping for some advice.
I have 2017 GT (RHD) manual, Edelbrock 2300, factory CAI, VMP BAP, full engine back exhaust with LTH and cats, id1050 injectors and Lund tune.
Car has been fine for the last 12 months.
In the last couple of weeks I've noticed some knock on the ngauge (+10)...
Toyo r888r?
I'm supercharged with 450kw at the wheels and my best 0-100km/h is 6.4 seconds!! Lol...
I've got Falken Azenis at the moment. But have had them prior to supercharging...
Thanks for your reply.
I need to replace the rears very soon.
A bit torn what to get but hampered with by my wheel choice offset etc..
Not sure I need a drag radial.
Anyway I'm rambling cheers...
Whilst I'm at it and trying to fix the leaking bottle. I'll try removing some of the fluid and see if that helps.
I'm currently using the factory CAI and was wondering what other options I have. I'm trying to avoid a retune.
Is the Edelbrock the only 'real' option? Also does the Edelbrock...
Hello.
My Edelbrock heat exchanger bottle/ reservoir has started leaking around the neck. Somewhere on these pages there was a fix but I can't seem to find it.
Not sure if it's the bottle or the lid.
I've tried removing some of the coolant to allow for expansion with no help.
I'm trying...