Search results

Thank you this helped alot

The tab is broken on the connector and I would like to replace it does anyone know the part number or where to get a replacement one?

This just happened to me after I did the digital dash install on my 2018 mustang. What is the part number for the bolt. Also any good videos to follow on how to replace the bolt thanks

my jugg tune was not good switched to ortiz car is running like champ

Cleaned mine and it was gone until I had to fill up again now it came back on. Gonna do a smoke test and see what I can find

saw some videos on youtube so i used silicon spray and the fuel adapter that comes with the car to clean in and around the filler neck if that doesnt work then ill take it to do a smoke test

so this popped up for the first time on my 2018 mustang gt. have about 80k miles on her. popped up earlier this week then didnt show up again til this morning. anyone have this problem?

Got a good deal on mbrp Street catback and wondering if it comes with connectors to connect to the headers or do I need another part to connect to my headers thanks

Ok thanks I'll do that right now

This is the problem

So Tuesday we had real bad rain storm come thru after which I noticed alot of water in the back drivers side area . I did a search on YouTube and I understand by the door jam there's a whole that's covered by a sticker. I check and the sticker is still there but isn't covering the hole...

ok thanks

https://www.americanmuscle.com/mustang-hvac-air-door-actuator-adjust-motor-604-295.html#customer_reviews is this the part i need?

thanks would the thermostat failing trigger a check engine light? also the temp gauge sits right in the middle

i see no today it was 74 degrees out and i raised mine to around 75 or 76 and it was still blowing cold

not sure but lets say it was. what you got for me?

have a 2018 mustang gt and just noticed before i would turn it up to maybe 70 or 72 and it would get nice and toasty but now i have to turn it up to at least 80 to get the same heat. only thing i did was install a jlt cai. also my coolant was low so added some more coolant to that. it was...

Thanks everyone one for the suggestions

Thanks I have a Dremel ill try your suggestions

It's from where you mount the maf on a jlt intake. I think I need something smaller like what they use for computer and phone screws