Search results

After doing a lot of reading and photo scanning, I've decide on a asymmetric Low profile Bendpak 2 post lift. Why? First Rotary is a better lift but $5k is more than what I want to spend. The reason for asymmetric and low profile is that it allows greater choice of where I want the car on the...

Right now I'm using wood blocks and groove is deeper then the weld, so i'm lifting via inch width on either side of the weld and they are about 3 inches long. So I went Amazon and none of the blocks looked deep enough and the main complaint is two soft and they split. Even the fancy alum with...

So wondering about asymmetric and low profile arms. Looking at the 10K bendpak. Both models have 4" minimum pad height, so will still need some drive up blocks.

the link is dead but I found it else where. I'll running the latest version of Windows ten on a surface pro 4.. Copied the disk to my hard drive and fixed my .ini file pointer. I have had to delete reboot reinstall svg too make it work. Great when working on the car to have the tablet there with...

Not unusual the tsobrowser along with Adobe svg viewer are out dated. So I removed the adobe svg browser, downloaded the 3.03 version. Rebooted installed SVG, set the icon for WSM TO windows 7 compatible, with start as admin. Rebooted again and wiring diagrams are working again.

A reminder, mark your tranny location, so you can put it back in the same spot. I just used a marker pen around the edges of the mount. If you don't put it back where it was you might get some vibration issues

Is it true if I hold the accelerator to the floor the engine will turn over but not start? I'd like to build some oil pressure before ignition. Thanks

so looking for video on belly. pan removal to fix oil pressure sender leak and info on heat shield

Do search there is an excellent video from the wheel showing it leaking as the engine is revved

So many mustangs have had there dashs out the dealers are getting good at it

Ford dealers are just blanks when it comes to GT350's. Especially when the service in question is different from standard mustang. I asked my ford service manager what's different on a Gt350 oil change from a standard mustang, he answer was I think it takes different oil. Any thing different...

Buy a 2017 it has the right stuff

Air supposed to be a self bleeding system, also search for leaky clutch line to reservoir

That is not what service bulletin recommends do a search and print it up, it will probably come loose again. Always check here before you let the average ford dealer touch your car

Have you adjusted your bumpers so that they put tension on the hood? Solved my problm

Got too adjust the hood stops to put tension on the corners, do a search

Service or lack of has driven most of my friends to Toyota or KIA because they like the way the dealer treats them especially for service. Whereas I dread going to Ford because they will do it wrong and screw you on price. However for warranty work I've found them OK but I always knew what was...

Ford really built a car that is beyond what the dealers can support, look at the engine they won't dealers work on them, thank god!

Well at least they did no harm, but just another ignorant dealer service shop

The AC problems convinced me to get the 8year $0 dedu enchanted rental and exterior lights