Search results

After a lot of aggravation and finally ordering the mmr install bolt, I believe I finally have my Ati damper on correctly. I am however worried that it may not be completely pressed on due to the gap inside the hub from the crank about to where the damper bolt washer sits. It feels like it...

Mods so far. Stainless Power longtubes MBRP Race Ported Boss I/M Ngauge w/ Lund Flex tune JLT GT350 CAI ATI Damper Boundary OPG TSS crank sproket MMR water pump pulley Moroso catch can MGW race spec GT350 steering wheel Raptor shift light UPR gloss black emblems BC...

I've had my stainless power headers installed for about a year now, and the alignment of the engine just now started bugging me. I have clearance at the top where the ac bolt was removed but further down along the frame rail one of the primaries is only an 1/8th inch from hitting. I've had...

I was just messing around trying to clean up the mess around the fuse box and trying to plot and figure where I can reroute some things and was wondering if anybody else has done or is working on hiding or tucking the clutter in the engine bay.

I was wondering if anybody who's had one of these engine opened up before could tell me if the scarring on my timing chain is normal. I noticed it today looking over the car, it looks bad to me for 4000 miles. Amsoil sig series for oil.

Is it possible anybody is running a factory gt350 air intake with a boss manifold? I want to upgrade my stock airbox and the factory gt350 looks a lot nicer but I'm not sure it will make the upward bend without the maf hitting the fan shroud so I was wondering if anybody has done it yet and if...

So I went to go upload my latest tune revision from Lund this afternoon before leaving work, tune loaded successfully , shut the car off for ten seconds per the instructions, go to start car and nothing but warning lights and chimes. I tried to load it again and then gauge will not read my car...

I'm getting ready to pull the trigger on a set of coilovers for my PP GT. I was looking into the bc's but just recently saw that ISC has come out with a comparable setup. I know that both companies are known to be a "bargain" brand but was curious as to which coil would be a better choice. I...

I wanted to make a post to get a few opinions on the issues in having with my MT-82. Mine has been problematic since I picked the car up. I have read up a ton on how these are noisy gearboxes and such and noisy I'm fine with....but mine seems to have 12 gears lol. Sometimes the car drives...