Sponsored

Search results

  1. U0415 + ABS + Air Bag + Advanced Trac Service

    What type of scan tool did you use to read the speed sensors? Bi-Directional?
  2. Whipple Air Filter

    What were the symptoms when driving? Any dash lights?
  3. Cannot select drive modes after failed abs module and wheel speed sensor

    What did this cost you? Dealing with a similar issue.
  4. [SOLVED]Abs light, hill assist fault light, power steering light, no parking assist light issue

    did your code come on intermittently when recycling the car on and off? If so, what scanner did you use?
  5. AdvanceTrac Service, ABS , Traction Control lights On

    Did you use blue or red loctite? If you used loctite, did you let it dry for 24 hours? Thanks man.
  6. AdvanceTrac Service, ABS , Traction Control lights On

    What torque specs did you use on the rear axle nut? The ford recommendation or the BMR recommendation? Also, did you use the service manual or a specific youtube video to help with the hub install? Thanks in advance.
  7. Rear View Camera Gone Wonky

    Mine is doing the same thing after they replaced the harness under the recall. I also have an intermittent wrench light / air bag light that comes on after 3 miles or a bump ( assuming the bump is causing the wires to shake throwning a code ). Any feedback would be appreciated. Thank you.
  8. SRS Airbag Sensor Issue - Need Help!

    Was it an intermitted light or did it stay on between on / off cycles of the car?
  9. Airbag light

    Where is this sensor located? I am having similar issues.
  10. AdvanceTrac Service, ABS , Traction Control lights On

    Which fuse box? The passenger side interior or engine bay?
  11. BMR Tech Tip: Check those axle-to-spindle retaining nuts!

    Where any of these wheel bearing issues associated with an intermittent airbag light, wrench light, as well as drive modes not being available due to the washer possibly interfering with the wheel speed sensor?
  12. Michigan no longer require

    no longer require.
  13. resolved

    Thank you.
  14. p2098 code

    the air leak was over cylinder 5 ( that is where that bypass 90 degree elbow is situated as you might know ) and I was getting a misfire code for cylinder 5 and a p0174 code. I changed all spark plugs and cleared codes. Misfire code disappeared and the p0174 came back. The air leak was found...
  15. p2098 code

    it was running lean due to a air leak from a fractured bypass actuator rubber elbow which I replaced but it should be all good now. It must’ve damaged the o2 sensor.
  16. p2098 code

    I appreciate it. Thank you.





Top