Search results

Wish I wasn't on the other side of the country or I would help! Anything you need Let Me Know!!! Best of luck to you Brother!! Love reading your adventures! I wish i had the time to travel the country and race my car! For now i live vicariously through you lol

Looks like it might be a PITA @honeybadger no time is listed for All Data SMH. Getting to those back Harnesses plus it Ties into the Transmission. UGH

I will check my Alldata at work tomorrow, see how long it books out for on labor, might lead us to a better direction. See if removing engine mounts or dropping transmission mounts and using a floor jack to tilt Engine/Trans is the way to go.

No Messing around with Race Car Do it right! If it fails while on a trip you'll regret it. Plus you will now have a spare with a patch on it! I think its this one. Correct me if I'm wrong.Looks cost effective...

This Help?

This happened to me also luckily as i was pulling my car out i looked behind me and saw an oil spot under where my car was parked. Jacked up the Drivers side and had to tighten my oil filter a turn and a half!!!! On these vehicles make sure your oil filter is on tight!!! 8200RPM can cause a lot...

Picking up nails/ screws in rear tires is very normal had one in mine a few months ago. the front tires roll over the "object" and it starts to tumble then the rear tire rolls over it snatching it up. I work in a tire shop see it all day long. If your tire shop allows you to Road Hazard a Ultra...

I'm not sure if anyone touched on this yet but I'm Pretty sure the motor gets dropped out from the bottom. drop front subframe and swap motor. bolt on accessories and fill with fluids.

I lowered my GT350 a few weeks ago and aligned it myself set toe in to .05 on both sides Tramlining is almost non existent now! So much better! I used the Ford Performance springs 20mm drop

For me the FPC engine that Ford Performance wont let anyone else buy unless you own THIS car! Worth the extra cost of a GT350. The exclusivity of this engine is worth holding on to this car! The Mustang GT cant get a BMW owner into the dealership to trade in his M3!

They sure do! Mine loosened up after 1000 miles two full turns. Thank God I always look under all my cars after I pull them out of their spot.

My lowering springs just arrived today! I ordered them through Summit Racing ordered them 4 weeks ago. installing them in a couple of weeks! waiting for the Spherical Lower control arm bearings from Steeda. I figure while I'm in there might be a good time to install those too. :ford:

Mine is Being delivered Today! LMR confirmed shipping Last week Thursday 6/22!

General Manager for Tread City Tire 15 years and counting.

I run a tire shop in Buffalo NY been doing tires 15 years the Nitto NT555G2 is nowhere near as sticky as the PS2