Search results

Kit needs a cam washer to stop the stock location from allowing any side to side movement at all. If Ecoblue has experienced the camber setting changing with use then something Preventing it from moving is a must.

It does.

Had a fun time. Wings were good as well.

I can or out in corner by trees

I gotta do a better job of estimating travel time. I'm here already.

I just got the same thing. Now the question is: how should they be setup?

No way I would risk a crash at 80 mph to buying some knock off parts to save 10 bucks.

Motor oil University http://www.bobistheoilguy.com/motor-oil-101/ http://www.drivenracingoil.com/news/dro/training-center/articles/dont-fall-for-the-myths/

Pic B

Pic A

I called Steeda and they asked me to take pictures of the plugs and submit to [email protected]..

What is the floppy rubber thing for if not for the sound tube opening on the intake? I had three pieces left over. One firewall plug(I already did the sound tube delete a long time ago), one black rubber floppy small sized condom looking Cap and one small hard cap like the one that goes into...

The sound tube rubber is a little Mickey Mouse. I need to find a better cap. The CAI kit is awesome other than that.

I know. I just guessed. Fits nicely. Now the question is, which way should you put it in? I did outside to inside.

Grats!

Anyone have any experience with water and the Roush heat extractors and your Steeda CAI?

Looks like you didn't install the little cap in the airbox hole near where the Maf wire is held in by the pushpin.. At least that's were I put mine.

I just installed mine this morning. I used a putty knife and kinda pryed one edge to bend the what seems like metal inside the rubber a little bit so it fit over the lip easier. Just worked my way around. Had about 2 inches extra to cut off.

If you want scientific data read Bobistheoilguy's dissertation on oil. After reading it you will find that 5w30 does not provide a substantial increase in protection at 220 -230 degrees than 5w20. Both perform similar below 200 degrees. But 10w 30 is a lot worse from a viscosity...

Today I installed the MGW shifter I bought a few weeks ago. Easily the best mod I've done so far. Shifts are 1000% better. I am truly shocked how good it works. Install took about 2.5 hours. Only real trouble was the rubber boot. I finally took off the upper portion of the shifter and...