Search results

I have a base 6 speaker audio system, so I didn't have the center speaker to deal with.

Yes, OEM Radio programmed my ACM for low level, unclipped outputs. After adjusting the amp gains, I do not have any low level noise. I ran the power from the battery along the passenger side, and the speaker and RCA's on the drivers side. The sounds is great and all the sync functions work.

Audio Harness Installed OEM Radio built one of these plug and play audio harness for me a couple a weeks ago. Finally had a chance to complete the install. What a breeze. After installing the harness I connected the Kicker 4 channel RCA cable to send the low level input signals (front and...

Premium ACM I installed a premium ACM with my MFT Sync 2 upgrade. If I have read this thread correctly, once my premium ACM was programmed for my vin number, the default would be high level speaker outputs since my mustang is a base model S550

OEMRadios' Da Man I completed the MFT swap in December and installed the premium bezel. During these months I have enjoyed the auto climate that the premium bezel provides except that the JMR programmed APIM was designed for the manual climate control bezel. No climate quadrant to control the...

With the premium bezel you have the auto climate control, without the dual zones.

Climate Quadrant Has anyone figured out how to add the climate quadrant back to the JMR programmed APIM. With the premium bezel, I've gotten use to controlling the temp blindly, but would love to have the display.

That would make this MFT premium upgrade fully functional (except for the heated and cooling seat buttons). Can't wait for your results Zack.

I used a 2015 escape screen and APIM. JMR programmed everything along with a premium mustang ACM. Then installed using a premium MFT bezel. Everything works. I'm learning to use the temperature control without having any feedback as to were it's set at. Not sure if the temperature quadrant...

I purchased a sat antenna adapter from amazon. Fakra yellow female to male SMB connector, the used a XM micro antenna I had. Placed antenna in the center of the back window and ran the wire to the ACM.

I'm done and I love it. Thanks to Zack, AggieStang, and JMR. Picked up a premium bezel and ACM with the help of JMR and his friend. Just need a USB adapter and blue Ford panel clips. Thanks to this forum and everyone that contributes.

Things came up. I will have to finish up next weekend. Thanks all for you help

Got it, Thanks Zack. I should have tried to pull back on the locking fingers to release the pin. I kept trying to push. Your bezel look great. Professorwoof I'll try again using a small flat head screwdriver to push the connector into the 240B connector. It's dark out here in New Mexico...

MFT swap. Just received my programmed APIM and ACM from JMR just this week. Thanks for your youtube links showing the dash disassembly.

Just ran into another issue with my swap. How do you release the APIM pins so I can change their locations? I'm sure there is a easy solution.

Zack, the bezel looks great. I just started my install and i'm having a problem inserting the WT1000 pin/wires into the 240B connector (ACM). I removed the locking sleeve. It looks like the gauge wire that comes connected to the WT1000 is to big. Am I missing something?

Just received my APIM and ACM from JMR yesterday. Plans are to do the conversion this weekend. I'll post pic when completed. Is there a post that describes the disassemble of the dash. Don't want to break too many parts. Also do you need to move/add any audio signals from the console jack...

I've been following this thread for a couple of months and now I'm all in. I just purchased a touchscreen and APIM (DJ5T-14F239-DD) from Ebay, and ordered all of the other parts needed from FordParts. Now I need to contact jmr061 about programming and zackmd1 about his complete faceplate...