Search results

I have had my eye on them but was turned off by the $129 price but I may give the Ikon Motorsport knock offs on ebay a try. gloss black $36/matte black $50.

shouldn't be a problem with custom tune

I haven't tried this one personally but according to reviews it works with ForScan. https://www.amazon.com/dp/B01N18TOFB/ref=cm_sw_r_cp_apa_i_GYFTCb1H52GCX

Thx for all the effort!!!

just need to call around to local shops that do custom tunes and has hp tuning software. it shouldn't be a problem finding a place in larger cities. the biggie issue wil be convincing them to do it since they may not be familiar with it. if you have plans of buying a tuner in the future this...

starts at post #977 and goes from there.

the only proven way is the custom tune, but holding out hope that the new sensor will be viable route. it involes new sensor and wiring in the 2 additional wires. if @dawolf can get it to work on digital cluster then I will see if this makes it work on PP gauge cluster. I haven't checked but...

@dawolf any update? thx

if you have programmer such as ngauge sct or Cobb Acessport then get turned on with custom tune. some are trying to get oil pressure gauge on digital gauge cluster to work by changing 1 wire oil pressure sensor to 3 wire sensor I'm hoping if this works this may also make oil pressure on PP...

no unfortunately forscan doesn't make changes to PCM.

need the sensor turned on in PCM, this is done with custom tune. Either that or you can find shop to make changes to PCM, one forum member had his shop that was able to make. change with hp tuning software.I was planning to buy Cobb tuner in future so Im going to go with custom tune.

could have been disabled with ForScan 7B7-03-01 x?xx xxxx Change ? To: 0 - Disable (off), 1 - Enable (on-default)

PP Guage installed, boost gaude working, next step to tune and get oil pressure working.

need to remove radio bezel and display. I was able to to pull the bezel far enough out to remove the 4 screws that hold display and than pull display out to access plug for pp gauges.

I did thanks for the help, got some work for the weekend

hey Benny do you think order#12532 will ship today? thx

I had my fog lights activated in forscan as DRL at one time and yes the car does have to be in gear on automatics.

yeah it was in that square slot in the plastic dash structure behind display. just had to push out from front and grab from behind.

that would be nice if you can replace the air duct assembly. I started doing the necessary modification to the dash for gauge installation. I decided to block off the center vent by cutting a piece of 1/8 plastic and securing over vent hole with a couple dabs of plastic epoxy.(pic below shows...

no worries, you actually responded earlier and saved me from making same mistake. ironically they still show incorrect picture. I was lucky enough to score entire pp dash trim for $137 shipped. I expected it to have some damage forcing me to wrap or sand to brushed aluminum finish but it...