Search results

Followed through Agbrigg (Wakefield) earlier by a Black 16plate convertible. anyone here?

Yep the left side is the same thickness all along and the CV’s are larger too. right side is identical. pic below of left side GT vs GT350

Sitting after a run to do the shopping.

This video shows you how to do the theme change. very easy to do.

To change the splash screens you need Forscan and a ELM327 interface. Forscan is free and the licence is free. The interface can be bought from eBay/Amazon etc for about £15/20 All the Sync 3 have different splash screens built into them but as far as im aware you need Forscan to change them...

Just quick wash

Not much of an update but the car is back on its wheels and driving. Exhaust is done and sounds great. Still quiet (ish) with the valves shut even on the motorway and not intrusive. Open the valves and shit the bed it makes some noise especially on wide open throttle. It does sound just...

Not the best picture but I have an oil pressure gauge and a boost gauge, both from Stack. They do the job nicely.

I bought the dash from the states (eBay.com) as it is cheaper. Fitting is the easy bit. You just need to use Forscan to program it all after. again easy after a bit of reading up on here. Just need to make sure you get the right dash as there is a manual and an auto. You can program the...

SVE R350 19x10 285/35 & 19x11 325/30

First time out the garage after fitting Eibach springs, 3.15 diff, GT350 half shafts, long tube headers, magnaflow tru x resonator SVE R350 19x10 & 19x11 wheels and other bits.

the tyres clear fine. Need to get the car aligned though as I can see the camber at the rear is off from one side to the other. the springs have dropped it 25mm at the front and 20 at the rear. Ride is nice and doesn’t feel any more harsh than the stock springs. non plans to do The ARB yet but...

Back on its wheels. Had a slight setback with a tune but all good now. Going to get a few miles on it over Christmas then back on the lift and recheck everything. Make sure there’s no issues and all is still tight.

GT350 axles fit the 15-17 with no issue and I think the same goes for the 18+ I have the GT350 axles in my 16GT

Yes the half shafts fit the diff. I have swapped from 3.55 to 3.15 and fitted GT350 just this week.

I slotted all the top holes on the drivers side and passengers side. Left the bottom ones alone.

I have built them before. my current kit is a Westfield made here In the UK. I didn’t build this one though. Bought it with minor damage and repairs it. A lot of fun and corners like you won’t believe. 180bhp 530kg and will hit 60 in 4 seconds. There are tonnes of them around. All shapes and...

There labelled as Tog headers but they are clearly xforce with small adjustments to avoid legal action I guess. Will be made in the same factory in China. Came from Australian eBay. Bout 500 delivered. pick of them next to xforce. Pic is from @SpArKy

Near 800bhp 700lbft+ and I bet I can still spin them up with ease.

Last up for today are the wheels. While buying all the bits to improve performance i was still struggling to put the power down through the standard tyre sizes. 275's just haven't got enough foot print to put near 700whp tot he ground so a wider wheel/tyre set was needed. I looked at a lot and...