Search results

I just received an e-mail and there is a fresh batch of these being made in black. The website allowed me to order one but if you want one you better get it on order before the batch sells out. As was mentioned above, he mentioned moving on to some other project after doing this batch of ponys...

Are there any other incentives available for me in the next six weeks or so? At the moment I have X plan and wanted to check if there might be something else to combine with it when my car arrives.

Maybe it was an econoboost PP they were talking about

I would like to have one, how about dropping me a PM so I can give you a shipping address.

You guys wanting all that stuff must be made of money.

Sounds like a few minutes with a hack saw will cure your problem.

That is a sore point with some people on here. The people who actually made that decision scan this forum and perhaps one of them will chime in but at this point it probably not going to smooth out any hurt feelings, mine included. It was the reason I took so long to get a Mustang on order...

Keep me in your thoughts when you travel to Tulsa Oklahoma. If you have the time I will be happy to buy you lunch or dinner at one of the local eateries. Doubt you would be interested in any of our watered down beer.

Sure is a disappointment to hear cause I was hoping that a bushing and maybe end link or two would suffice to get rid of the wheel hop.

Before making a decision you and her should drive tot he nearest Ford dealership that has a yellow car in stock and check it out first hand, hopefully next to some other color you are also considering. That is what I did to make up my mind.

How is the noise level? Can you hear the SC at all while just driving around normally or sitting at idle?

A guy here at work just bought a 1964 Belvedere that is factory original except for headers. It is one of the 426 Wedge cars that has dual 4 barrel carb's. It cost him out the nose but he drove it to work last week to show everybody. Dang thing has push buttons on the dash for shifting the...

A couple of questions. Is there a reason for the Procharger aluminum coolant overflow container rather than keeping the factory plastic piece, other than looks? Is the kit truly no hack and cut, meaning that if a person wishes the car could be put back 100% stock? Is anything useful discarded in...

Not a movie but they had a Triple Yellow GT on Wheel of Fortune last week.

I like it a lot. How much lowering on the front? What was mechanically done to lower the car? Springs and alignment? Spindles?

How does color play into the build sequence? I ordered a yellow GT the last week of December, knowing that the production line was down and wouldn't be back up for a few weeks. If they do a batch of yellow cars then perhaps mine will be done at roughly the same time as Toplessfun's car.

I haven't received mine yet but I will run 87 all the time unless some mechanical issue dictates otherwise. For years I have owned a car that recommends 91 octane or better and it will be nice to get to fill up with the cheap stuff.

Check out http://www.thejacketstore.com/ford-keyless-remote-cover-frdb94/ They even come in different colors Silicon Rubber. $7.99 each I bought two in yellow.

Also, keep in mind that it isn't just initial cost to purchase. Cost over time is real important unless you have enough to budget it in. When I checked into getting one a few years back the insurance was sky high as compared to other cars I was looking into. My debate at the time was between a...

He is serious. New York is a different world. I went to college with a guy from New York and he had never even ridden in a privately owned car, just cabs or subway or a bus. My contribution to his education was to take him out in the sticks and let him drive my pickup around for hours on the...