Search results

Interested in buying a Blockit trunk mat, price shipped to 85715. I am also willing to drive up to the Phoenix area to pick up as well.

Installed both of these and took them off a few days later. Shifting was a lot more precise and smooth, especially during cornering or when the engine is under load. The added NVH was just too much for me as the car is my daily driver and I prefer the car to be on the quieter side. Note: I...

For sale are a Steeda IRS Bushing Support system (555-4437) and Alignment kit (555-4438). The bushing support system did a great job at reducing wheel hop with minimal NVH. The alignment kit ensured that the rear sub frame was properly centered. I am selling both since I replaced all the rubber...

For sale are a used pair of 20mm billet aluminum hubcentric wheel spacers I bought from OPMustang. I ran these with extended ARP studs, open ended lugs and -2 to -3 degrees of camber with 19x11 SVE 350 wheels +50 (track) as well as 19x11 SVE GT7 wheels +50 offset (street). They provided plenty...

Bought brand new GT grilles (upper/lower) with the intention of installing custom plastic honeycomb and textured backing similiar to how the GT350 grille is designed. I no longer have time for the project so decided to sell. These grilles are brand new and have never been installed. I cut out...

Selling a used FRPP Oil Separator "Passenger side" off of my 2016. Bought this brand new a couple of years ago and has performed flawlessly ever since. Always captured a good amount of oil in between oil changes (and track events). I am only removing it since I decided to go with a custom oil...

Noticed clunking in the rear at low speeds (10-15mph) over rough patches of road so checked the rear suspension and noticed the driver side differential bushing to have significant damage. The car has 51k miles and over 25 hours of hard track time so I'm guessing the repetitive heat cycles from...

Let me know a price shipped to 85715. Thanks.

Selling a set of Steeda Sport Linear springs I recently pulled off of my 2016 Mustang GT daily/HPDE car. These springs have a spring rate of 200lb/in front and 800lb/in rear with a 1" drop all around. In my opinion, these are a great choice for a car that will see a lot of daily driving as well...

Looking to trade my base cloth black seats out of my 2016 GT plus cash on my end for a pair of cloth Recaros. The seats are in great condition with no noticeable wear or damage. Would prefer a trade within Arizona (I'm out of Tucson), but will consider driving out a fair distance to make the...

Selling a set of four satin black 19x10 SVE GT7 wheels with 275/40/19 Hankook Ventus Evo 2 tires and factory TPMS installed. Ford center caps and a set of brand new SVE center caps are included. Wheels are mounted and balanced and ready to go! All tires are within 6-7/32nds with plenty of...

Pulled this exhaust off of my 2016 to go back to stock. The Corsa's sounded absolutely amazing, almost kind of GT350ish in a way, with ZERO drone. There are some scratches on the underside of the mufflers and the tips. Not noticeable once installed. I refinished the tips so the Corsa logo is no...

Selling a 2015-2017 Borla S Type Axle Back that I just pulled off of my 2016 GT. I am the second owner of these. When I traded for them (used to have Roush before this), I noticed what sounded like fine grains of sand inside the muffler. The original owner didn't notice since they didn't have...

I am looking to trade my Corsa Extremes (Sport axleback) for the quieter Corsa Sport (Touring axleback). Hoping for a local swap near Tucson, AZ. If you are interested let me know!

Selling the Triple yellow hood vent inserts with turn signals off of my 2016 Mustang GT. The inserts are fully intact and the paint is in good shape. The wiring harness needed for the turn signals to work is also included. $80 + shipping. Located in Tucson, AZ.

As title states, looking for an un-cut stock exhaust near Tucson area. If you have one you would like to get rid of let me know!

The Borlas have a great deep and throaty sound to them, but I am looking for more of that exotic/raspy sound the corsa tourings may have. The Borla's are in great condition with no noticeable scratches on the tips. I would clean them up nicely before the trade. If you have Corsa Touring and are...

Looking for a HANS device. I'm particularly interested in the traditional HANS or a hybrid type, but... open to other types as well. Let me know what you have and price shipped to 85715. Thanks.

Looking for a driver side Schroth QuickFit Pro harness for my 2016. It can be any color. Let me know what you have and price shipped to 85715. Thanks.

Looking to buy 2 x 2015-2017 GT Upper Grilles for a custom project. I am also willing to buy the cutout honeycomb from someone whom inserted mesh into their grille... given that the honeycomb portion is all in one piece and undamaged. Let me know what you have and price shipped to 85715. Thanks.