Search results

Above the door latch is a spot to manually lock the doors with the key.

Black TTT

I agree, wheel locks mostly cause problems for vehicle owners. On my 17 GT, 2 of the dealer installed wheel locks sheared off leaving behind pieces that could not be turned by extraction tools. I ended up having to drill out the wheel studs and replace them. It was extremely frustrating and time...

Sounds like a nightmare! Most of the time that I’ve experienced DTC’s with “intermittent” in the definition it’s accompanied by an unstable electrical circuit. I like the idea of trying out a non-modified wiring harness. Wires can appear ok on the outside but have the internal strands pulled...

That sucks man. At least you minimized the damage and it looks like a relatively easy repair for a competent body shop. Good luck on the repair.

Do you have the shift light setting on track mode? If so the gray bar stays displayed all the time and will not show song titles. Try changing the shift light settings.

:like: :fistbump:

No problem, looks amazing!

Have you tried changing the “heater current monitor” from disabled to enabled? The PCM normally monitors the oxygen sensor heater circuit current for fault detection. If this option is disabled then the PCM will not be able to verify the oxygen sensor heater operation which is a prerequisite to...

I’m not sure of the exact wheel weights but the front wheels said 34lbs on the box, 32lbs for the rear. These were in machined finish with silver painted sections in between the spokes.

Sold, thanks everyone.

Here’s some pictures of what’s inside the stock resonator https://www.mustang6g.com/forums/threads/stock-resonator-cutaway.120726/

Thanks for the replies everyone. I’ve decided to sell the wheels since I don’t want to change the Bullitt wheels. See my post in the classified section if interested.

I feel the same, hopefully whoever buys them can upload some pics of how they look. Thanks.

New wheels still in the boxes. Never been mounted or bolted on. I had these planned for my previous S550 but it was totaled and I have a Bullitt now. These wheels cost $595 new from American Muscle. Sizes are 20x8.5 and 20x10 $400 takes them. Local pick up only at this time. Houston,TX

I wonder how the stock wheels would look in anthracite, especially on a black Bullitt. Stock looks good but some anthracite would be nice so everything isn’t black. Has anyone painted the stock wheels?

No, I bought them from American Muscle. I’m most likely going to end up selling them though since I like the Bullitt wheels.

I experienced similar conditions after doing the power pack 1 on my 2017. The software is very sensitive. You must keep the gas pedal to the floor. If the pcm sees anything less than 100% of throttle input, NLS doesn’t work. You have to stay committed and shift like you mean it for it to work...

My 2017 GT (Manual) had 1100 miles when I bought it as a “new car” from a ford dealership. It was produced late in 2016 and had never been sold. I bought it in late 2017 right when the 2018’s were rolling in. They claimed it was used for road trips by the finance manager. I didn’t believe them...

I had these wheels planned for my previous S550 but it got totaled after I was hit from the side. I put them near my Bullitt to see how it would look. I’m still not sure since I do like the Bullitt wheels, but these look good too. I have time to decide since my current tires are new. What do you...