Search results

Jaime, unboxing those bad boys will be like Christmas when you were a little kid for sure. And I thought 345's on the back of my girl were wide. 😳 I've purchased 6 sets of wheels from Terrance and there has been no one better to deal with. He's become a close friend and always enjoy working...

Exactly!!

Never heard of Cream of Wheat bread but I sure do like Cream of Wheat. 😊

Also, good to hear from you, Kent. I'm on a few times a week checking to make sure you're keeping things in order. 😊

I've had the Morimoto Gen 1 LED headlights along with their turn signal/parking lights for over 4 years and haven't had a single issue with them.

The lift itself is considered portable since it has rollers however it weighs right around 1,000 lbs so I can tell you it does not roll that easily without 2-3 people. The 4x4 stop blocks front and rear are bolted down to the floor. The lift is not bolted down (no way to do that). As it goes...

My two-car garage has a low ceiling of just under 9 feet. About 6 years ago, I purchased the BendPak MD-6XP mid-rise scissors lift. There might be better options today but this lift has served me well beyond what I expected. I modify suspensions on many cars and I'm constantly changing wheels...

After looking at several photos of my car with the turn signal lights on in the running/parking mode, they are all on but the one in the corner is brighter so it makes it look like the others aren't on. They don't flicker when taking a photo like the rear taillights do, they are fully lit in...

Jaime, I just saw all your posts on the Morimoto turn signals. When they are on in the running/parking mode, is just one of the LED's lit or are all of them lit? Mine never just have one lit like I am seeing in your photos.

No way would I put the OEM blinkahs back in. They aren't smoked and LED. The Morimoto blinkahs are so much cooler looking.

When I eventually get these (a little too busy with other projects right now) I'll be going with the same setup, white DRL's and sequential blinkers. The thing is, I already have Morimoto LED sequential amber blinkers below so not sure how it will look having two sequential's on each side. I...

You beat me to it. Any PHOTOS??

Not sure if this helps but it's from the 2020 Ford Mustang Repair Manual on climate controlled seat operation:

The Shelby has standard '15-'17 headlights. Nothing special. I've had Morimoto headlights on my Shelby for over 4 years and they give it a completely different look which is what I was after. These new Morimoto's just update that look. Not only that, I'm hoping they are brighter than my...

I really like them! I may replace my current Morimotos with these.

You would connect it this way if the amp is rated for an 8 ohm load like the one in your diagram because it's bridged. If it is not a bridged amp and a standard mono 4 ohm amp then connect it up to the dual voice coil woofer but don't use the jumper.

When you mention you want to tie the two positives together, are you talking about the two on the dual voice coil speaker or the ones coming from the audio system that will be supplying the signal to the amp?

Hey Tyler, I don't have the wiring diagram for the 2017 audio system so not sure about the wire colors you have. Also I cannot say with your system that you can join the two positive audio sub wires together like I did with the B&O system. Do you have a B&O audio system in your 2017? I'm really...

Same here.

My DD