Sponsored

Search results

  1. Strange and frustrating issue here

    you have a tuner that is willing to tune you with a mpvi3 ?

  2. intakes

    no you epoxy them open and port them

  3. Just bought the stang and ready to make my first round of mods (cold air intake, LT headers, X-pipe, axle-back active exhaust)

    ebay headers. cheap and work just as good. if you are going to be doing a lot of mods. buy a car lif

  4. built short block vs rebuild vs new crate......eager to hear your opinions.

    a new gen3 shortblock will hold all you need no problem. but if you want a built gen2 shortblock i have one for $3500

  5. intakes

    i can get pics. maybe tomorrow

  6. intakes

    when i ported my 18 i did the porting then filled in the gaps from the imrc's and smoothed it out so it was like the imrc's were never there. just smooth runners

  7. Check Engine Light (CEL) on after Kooks 1 7/8 Inch Long Tube Headers 2020 GT 5.0

    angling them down doesn't hurt anything so why not

  8. Check Engine Light (CEL) on after Kooks 1 7/8 Inch Long Tube Headers 2020 GT 5.0

    if you run e85 you want your o2 sensor installed at a slight downward angle. if you have them installed at a downward angle they will last just as long as on gasoline.

  9. Ecoboost performance pack swap not reading boost

    with forscan you can turn this on

  10. Piston+rods for gen 2 coyote / block strength

    yup

  11. The "Correct" Plug for High Boost.

    this is not 100% accurate. the heat range is the amount of heat a plug retains not how hot it sparks. a plug two heat ranges colder will still produce the same spark. the voltage doesn't determine how much heat a plug retains ether. heat range refers to the insulator. on e85 the combustion is...

  12. The left hand fuel starve

    all they have to do is give free entry into the raffle and they are safe from gambling laws. there's always a way to get atleast one free entry

  13. Piston+rods for gen 2 coyote / block strength

    for this power level install cylinder supports and leave stock or just leave stock

  14. Check Engine Light (CEL) on after Kooks 1 7/8 Inch Long Tube Headers 2020 GT 5.0

    ether the damaged the 02s during install or the tune is wrong. i would do what was suggested and swap 02s

  15. intakes

    if it gets 40 more torque over the gen2 gt manifold that's like 60-80 more torque over other manifolds

  16. intakes

    that's what i'm thinking. now if porting it could gain some top end it might be worth doing

  17. intakes

    the truck manifold and 15-17 give a lot more torque down low but fall off early. so what about porting them? will it make a difference ?

  18. intakes

    everyone gets the GEN 3 intake manifold and usually gets it ported. We all seen that it does good up against other manifolds, but they always put the ported 18 up against stock manifolds so how does a ported GT 350 measurement or a ported stock manifold. I don't think I've ever seen a Dyno pull...

  19. Centri sleeper

    procharger kits come with a filter on the bov and it quiets it way down

  20. Of these 3 mods, which one would you do?

    you don't think number two or number three would void your warranty?





Top