Recent content by JLTH2183

After spending $800 to replace my VMP twinjet throttle body my car was running great again until the VERY next day. My traction control, ABS, & Airbag light came on with DTC U0415 Invalid Data Received From Anti-Lock Brake System (ABS) Control Module. After doing some research, this DTC can be...

I tried a KAM reset this morning with me SCT device and no change

Yesterday and today with no change :-(

I took apart the throttle body again and removed the Bosch electric motor and confirmed it works when I supply power and ground. After putting it back together I still have the throttle body stuck closed DTC. I removed the VMP harness extension ( its in series inbetween the factory harness and...

I have a 2016 Mustang GT Mt82 with VMP Odin with P2135 throttle body death code. I have twin jet 69mm throttle body that apparently VMP doesn't make anymore and they now have a twin jet 67mm in black for $850.00. I have my old original stock throttle body and since the twin jet 69 vmp uses...

Correction now making 10psi with larger pulley. I believe I only have the 56lb injectors that originally came with the VMP Odin kit. I use just the 4oz boostane shot.

Sorry for the long story in advance: My car is a 2016 GT Mt-82 PP car with VMP ODIN with Kooks LTH and super high flow cats 😆 ( cough cough maybe hollowed out b/c I previously found the driver side honey comb cat melting) with full 3" AWE exhaust, tuned by VMP. I have other mods too but the...

Time consuming for sure but the end result is great. Some may argue that its not worth the time to do all that but different strokes for different folks

Yes I too applied RTV at those areas but also along the bottom where the rear main seal plate meets the oil pan. I did not cut the brown rope seal short, just flush to where it ends but I also applied some RTV in the end of the channels.

I removed mine on my 2016 GT and ++++ 😅

I had a slow leak at my rear main seal and I finally got around to replacing it, the RPM sensor, the pulse wheel and also replaced my pilot bearing. It was not fun having to pull the trans again but if you seen my old posts I'm pretty good at doing it 😅

Yes I agree. I too removed the battery box and shielding

Also if anyone else is attempting to do this and they have the same set up as I do (Gen 2 coyote with VMP Odin) you will need to cut the little tabs off the top area of the valve covers first and then powder coat them and then install them. I forgot about this when I initially installed the...

Yes the stock Gen 2 dip stick tube works perfect but I had to order a replacement bc the little locking plastic yellow tab broke on mine

I purchased them from summit racing, at the time they were $270 for the pair. I had them powder coated here by a local shop. The color is called lolly pop red from prismatic powders. https://www.prismaticpowders.com/shop/powder-coating-colors/UPS-1506/lollypop-red...