Hi all,
I did some searching on these forums and wasn't able to find an answer to my question. Is it possible to reduce how loud the double horn sound we get when closing any door while the car is running? It's just so freaking loud and kinda ruins the whole attempt at being quiet in the...
Sure thing! I'm ok with taking a pic for you... I can lay a tape on top of it too so you can see clearly. I'll have a pic mid day tomorrow and see if I can DM it to you. Either way I'll make sure you have the measurements with it.
Look forward to seeing your results!
Hi there! So sorry for the late response.... I haven't logged in for a while. If you haven't painted yet, I can take a pick with a measuring tape tomorrow and let you see the exact dimensions... I can tell you the red pin striping was set to match the width of the stripe on my steering wheel...
This is nice to know you have what I'm planning to do... I have a very curious question(s) 1). How does it feel after installing? 2). Any noticeable rev changes? 3). I have a theory that using that CF Drive Shaft will actually reduce the loss of power from crank to tires, by chance did you do a...
Wow! Ok, so there is definitely a consideration to alignment.... Installing the CF driveshaft (will be going with the one piece QA1 for my '17 GT 6spd...) isn't too difficult, but when I decide to lower the engine, would you recommend I have a shop do it so they can line everything up?
I'm...
Anderson composites told me that I would have to cut the back of the hood because it's the same design as the OEM even though theres a bout a 2-3in lift... It's all about the back end of that CJ that's the issue. Yes some hoods would have that issue but unfortunately the I want still does.
I'm...
:crying::crying::crying: that's really to bad... My future plan is to add the CJ, ARH headers, and a 6 bladed carbon fiber vented hood from Aderson Composites.... I was really hoping those motor mounts would still allow for the strut brace.... however, it sounds like I at lease wont have to cut...