Benwilj
Active Member
- Thread starter
- #1
Sorry for this guys but I can't seem to find a remote wire source in the driver side foot well. I've ran 9wire up to the factory amp molex location and planned to use the ninth wire as a remote turn on wire, the other eight are RCA signal wires. I know the stereo wiring sticky says there's one in the trunk but I'm already here.
None of the factory amp molex contain a 12v accessory wire so I thought I would investigate the factory harness that runs down the door sill and has connectors just below the factory amp. I found one in a molex that should have worked think it was a purple/green 22ga wire in a molex with a orange snap cap. It measured out right at 12v with key on but when spliced into, my new alpine PDX-V9 amp blinks blue. For comparison, the blue light is solid when remote is ran directly to battery. For some reason the amp doesn't like that remote turn on source.
Anyway my question is:
Does anyone one of a wire in the ds foot well that works for this?
None of the factory amp molex contain a 12v accessory wire so I thought I would investigate the factory harness that runs down the door sill and has connectors just below the factory amp. I found one in a molex that should have worked think it was a purple/green 22ga wire in a molex with a orange snap cap. It measured out right at 12v with key on but when spliced into, my new alpine PDX-V9 amp blinks blue. For comparison, the blue light is solid when remote is ran directly to battery. For some reason the amp doesn't like that remote turn on source.
Anyway my question is:
Does anyone one of a wire in the ds foot well that works for this?
Sponsored