galaxy
Well-Known Member
- Thread starter
- #1
OK, how does the motor on the exhaust valve operate? Got my Borla muffler. Took the motor off the stock muffler to move over to the Borla muffler. With the valve completelely closed on both mufflers, the slots on top of the valve that accept the spring/coil thingie are a solid 45° off from matching. Thus, the motor and coil thing will not sit down into place on the Borla muffler. In addition, at no where in the range of motion between full open and full closed will it align with the coil on the motor.
I can get a screwdriver in there a Force the coil into the two slots, but being indexed that far away from each other, I’m not sure if this is the right thing to do. Don’t understand how the motor works; more specifically how it references open/closed as starting points.
Currently awaiting a reply from Borla but thought I’d pitch it to you guys while I’m waiting to see if you had either seen this or had some advice.
I can get a screwdriver in there a Force the coil into the two slots, but being indexed that far away from each other, I’m not sure if this is the right thing to do. Don’t understand how the motor works; more specifically how it references open/closed as starting points.
Currently awaiting a reply from Borla but thought I’d pitch it to you guys while I’m waiting to see if you had either seen this or had some advice.
Sponsored