Who is Running Aftermarket Motor Mounts?

[samcrac]

Who here, if anyone is running aftermarket motor mounts; either due to blower clearance or to clean up any movement from the stock mounts?

I'd just like to have your feedback on what type, and the biggest differences you notice? Also if you could comment on any added NVH. Thanks!

Sponsored

 

[Jeff_oddo]

I just had these motor mounts nstalled this week along with my headers. They are firm but not super annoying vibration wise. http://www.jpcracing.com/2011-2013-gt-boss-5-0-urethane-bullet-motor-mounts/

 

[Plimmer]

I've got the MMR's
Lighter and smaller than stock
Seems to firm up the drive line, I haven't missed the 2nd to 3rd shift since installing them
You do notice them with a little extra vibration, mostly noticeable at start up, but normal cruise I can't tell the difference.

Bottomline is any aftermarket mount will be a compromise between firmness and NVH

 

[Jeff_oddo]

I've got the MMR's
Lighter and smaller than stock
Seems to firm up the drive line, I haven't missed the 2nd to 3rd shift since installing them
You do notice them with a little extra vibration, mostly noticeable at start up, but normal cruise I can't tell the difference.

Bottomline is any aftermarket mount will be a compromise between firmness and NVH

Same with mine... Only really feel the very slight vibration when I start up.

 

[Super Werty]

I'm running steeda. Lowered 3/4 inch. At first the nvh was insane... But it has really died down in the last 500 miles. I used the stiffer poly in my set up

 

[BMR Tech]

I have ours (duh)...and really like them.

They start off a little harsh, but it gets better.

I started off with solid Delrin mounts before we offered our kit....and it was like going from a legit race car to a Cadillac once I went with our Poly Mounts. lol

 

[pinero61]

BMR's poly mounts paired with Boomba's trans mount. Really solid setup, and the NVH increase is minimal from both.

 

[LethalPerformance]

We're running UPR's mounts on our Shelby GT350 w/Whipple to clear the factory hood. The car drives great without any issues.

 

[Obsol3te]

I have 3/4" billet/poly drop mounts.
Comes with the KB kit
No noticeable NVH increase

 

[Dntalman]

I am running BMR mounts with the blower I bought from you.. Car is almost finished... I will let you know how I like the mounts..

 

[rainmaker]

BMR's poly mounts paired with Boomba's trans mount. Really solid setup, and the NVH increase is minimal from both.

Same exact setup here - works great!

 

[essque]

I got the rksport heat extraction hood and it didn't clear my supercharger so I got the UPR mounts and I'm having them installed tomorrow. Does anyone have any install tips or is it pretty straight forward?

Sponsored