VelossaTech
Well-Known Member
- Joined
- Nov 6, 2015
- Threads
- 30
- Messages
- 379
- Reaction score
- 244
- Location
- Florida
- Website
- www.velossatechdesign.com
- First Name
- Dan
- Vehicle(s)
- Ford Focus ST
- Thread starter
- #91
hey guys,
Latest production level part just made. This part is 95% of the final design, there may be a couple tweaks. This part shown here has some blemishes, so ignore those.
I added aspiration ports on the outer rim of the intake, so incase a very high horsepower car (in excess of 650 whp) uses the intake, it will allow the engine to breathe if the front grill isnt enough.
There are also strengthening ribs and I included a more gradual divergence angle at the outlet to help re-distribute the flow back into the intake when it expands from the grill to the intake port.
Hope you like it.
Latest production level part just made. This part is 95% of the final design, there may be a couple tweaks. This part shown here has some blemishes, so ignore those.
I added aspiration ports on the outer rim of the intake, so incase a very high horsepower car (in excess of 650 whp) uses the intake, it will allow the engine to breathe if the front grill isnt enough.
There are also strengthening ribs and I included a more gradual divergence angle at the outlet to help re-distribute the flow back into the intake when it expands from the grill to the intake port.
Hope you like it.
Sponsored