2016 lambda sensor failed 1200 miles

By chance did you use any kind of gasket maker when installing the new headers? I ask because on my Pypes instruction sheet it specified making sure to use a sensor-safe type gasket maker.

Some folks say gasket maker isn't even necessary, but anyway I'm curious myself in this case.

This is how I did it with my SW headers.

Major League Infidel said:

This is how I did it with my SW headers.

Click to expand...

Exactly what I'm lookin for, thanks bud!

Now to order a couple bung holes and bung hole plugs

Worked great. Never fouled another set of O2s

Major League Infidel said:

Worked great. Never fouled another set of O2s

Click to expand...

Great news. I already ordered a couple new bungs

Major League Infidel said:

This is how I did it with my SW headers.

Click to expand...

Do you by chance have a pic how these sit once installed?

Thanks!

stoli said:

Do you by chance have a pic how these sit once installed?

Thanks!

Click to expand...

2nd that

I never took a pic of that. However, they had enough clearance to miss the car if that is your concern.

The front sensors have enough room to be relocated up to 45 degrees

I read somewhere that u can use 6.2 f150 front 02 sensors on our cars and they're cheaper?

48.10 each for the factory mustang Motorcraft NTK hego is cheap .

Damn looks like I just fried one of my 02 Sensors at the track last night. Stainless Power E85 FF tune as well.

Group buy on o2 sensors.


Sent from my iPhone using Tapatalk

Luckily they are cheap and easy to swap out. Moving the 02 Sensor not so much. lol

I think we should make stainless works about this 02 bung location. Maybe they can start finding a solution