18x10+42 CF5 + 5mm spacer +camber bolt question

strengthrehab said:

I have my wheels mounted on my car for my track setup. No spacer was required for clearance. Thing is, I also had an alignment with camber bolts and camber was maxed out at -1.3 with wheel very close to the strut.

I ordered 5mm spacers in hopes the spacer will allow enough clearance to increase camber with camber bolt. If not, I will just get plates.

Will I be able to get more camber?

Click to expand...

BmacIL said:

Thanks for this. Glad to know an 18x10 +42 fits without issue to the strut.

Click to expand...

strengthrehab said:

I did order and will install tomorrow the 5mm spacers. Still not sure if I will bother trying to get more camber. I only need 0.7 degrees.

Click to expand...

Paul@PKAUTODESIGN said:

Its only a matter of 2 mm brotha, it would fit just fine.

Click to expand...

BmacIL said:

I've seen pictures of 20x10 at +40 that were pretty darn tight to the strut, so I figured +42 might be getting a little close for comfort.

Click to expand...

ihavefat said:

was that really all the camber you could get up front? I have -2.5 on slotted struts and i do not rub (I am still on stock wheels). Most likely I will go the spacer route if I can get my hands on decent track wheel setup

Click to expand...

ihavefat said:

was that really all the camber you could get up front? I have -2.5 on slotted struts and i do not rub (I am still on stock wheels). Most likely I will go the spacer route if I can get my hands on decent track wheel setup

Click to expand...

earlingy said:

Those 18's fit over the Brembos and look good, I'm jealous... what size tires?

Click to expand...