Sig556's latest activity

Do not overthink the problem B/A is correct IMO. I would SLOWLY drill out the bolt till it gives up and pulls free, Check the hole and...

Don’t be a moron and just hog out the hole. Soak it with pb blaster and drill a small hole then bigger then bigger. Eventually the bolt...

Looks great any slop in the chains?

If you let these guys choose your exhaust, I foresee your future thread... "MY EXHAUST IS TOO LOUD" 😅

Best advice hands down.

From what I am reading it appears BMR is no longer the company they once were. I have used their parts in the past and had good luck...

FWIW the gentleman whose services I used at the local racetrack who works on Mustangs to do my suspension setup refused to use BMR...

Well for one thing it's not the car as they are drilled and welded in a fixture or jig. This is an easy fix for you. If you are keeping...

In the last picture the splashed oil is acuminating on the outside of the pipe toward the tire not toward the pinion. So I'm thinking...

ARP hardware everywhere you touch.

I agree 100% with HKusp. You have your engine apart and you are right there with everything exposed. If you are going to keep the car I...

"You made the Plan Stan" Congratulations on your build , Stay safe.

You have $7477.00 in parts before you even begin the build. God knows what the intensive labor will cost. And when you are done should...

Biggsy, Now that is a clean and neat install. Well done.

I have had R1 Concept E-Line series Drilled and Slotted rotors on my last three GT's. 2015, 2018, and, 2020 GT Premiums. I have had...