Matthewstorm
Well-Known Member
Us Dragons gotta stick together.Haven't seen those before.
But I've got the same dragon on my window.
Sponsored
Us Dragons gotta stick together.Haven't seen those before.
But I've got the same dragon on my window.
Same here.I ordered the Roush scoops to match my car from an ebay seller and saved a few bucks. They actually shipped direct from Roush. Fit and finish is nice.
Unless you're cutting a hole for actual air ventilation or running tubes for brake ducts or similar, these are just bulky stickers. I put them in the same category as caliper coversLooking at Roush and American Muscle MP Concepts side quarter panel scoops. Any opinions on either? Pics would be helpful.
I hope you feel better now that you got that off your chest.Unless you're cutting a hole for actual air ventilation or running tubes for brake ducts or similar, these are just bulky stickers. I put them in the same category as caliper covers
You asked for opinions. Just stating mine.
I cheap harbor freight heat gun will make quick work of anything held on with 3m tape. Also works wonders on vinyl stripes.Baldilocks - did you take your off yet and if so how was it? Use a heat gun? Thanks.
Don’t think that there is one that covers 100%. That’s why I’ve left mine on for now.CS spoiler holes - is there another spoiler that will vcover or use the holes?
Not sure if it's changed for the 2019 and up California Specials, but I recently installed the GT350 track pack spoiler on my 2017 and it covers the existing holes. I was able to use two of the existing holes. But had to do some drilling.CS spoiler holes - is there another spoiler that will vcover or use the holes?
Do you have a link to the one you purchased?Not sure if it's changed for the 2019 and up California Specials, but I recently installed the GT350 track pack spoiler on my 2017 and it covers the existing holes. I was able to use two of the existing holes. But had to do some drilling.
For the outer edges of the spoiler I had to drill two additional holes (one for the outer most bolt and one for the alignment post). Also had to drill two holes for the center bolts, since the CS spoiler bolts line up vertically and the GT350 (or any other OEM spoiler I believe) are lined up horizontally.
While I am 50/50 on the look (kinda like it/kinda of IDK) it’s less aerodynamic and must contribute some wind noise.Unless you're cutting a hole for actual air ventilation or running tubes for brake ducts or similar, these are just bulky stickers. I put them in the same category as caliper covers
You asked for opinions. Just stating mine.
https://www.levittownfordparts.com/sku/gr3z-6344210-bc.htmlDo you have a link to the one you purchased?
Thank you !