FastCarFanBoy
Well-Known Member
OP did you pull the wheels or did you not make it back to the track?
Sponsored
I agree... the folks calling a 1.9 60ft pretty bad on street tires have a warped sense of what's normal for most people. In truth, most people on street tires are averaging over 2.0x 60ft times. When I say average, I mean all people at the track.. not an average of only those people who have been drag racing for 15+ years.Tyguy, I think your expectations might be a bit high. The 2000+ DA, your stock engine and 3.15 gear do not make for a record setting combination. That DA is pretty common here in the Midwest during summer so there is not much you can do about that. I see cars equipped like yours at my tracks every week in similar air to yours. Your numbers are most certainly in the ballpark.
Hes on drag radialsI agree... the folks calling a 1.9 60ft pretty bad on street tires have a warped sense of what's normal for most people. In truth, most people on street tires are averaging over 2.0x 60ft times. When I say average, I mean all people at the track.. not an average of only those people who have been drag racing for 15+ years.
Discounting driver skill, the prep of the track plays the biggest role, next is tire (some street tires are stickier than others), air pressure, transmission type, gearing, etc.. there's a laundry list of variables
I once cut a 1.77 60' on stock gatorbacks in my stock 2003 Mach 1; however, the track was prepped very good because it was days after a NHRA Pro National event, the DA was in the negatives and I had a near perfect launch. That time is an outlier and not representative of what anyone could expect in any condition.
Tony
For the record that was on a bias ply. And initial pressure was around 18lbs or so.Just a little video. To help you understand the point I’m trying to make OP. Notice in this video. he goes faster after he lowers the tire pressure and leaves harder. Starts at 21psi. Lowers it to 15psi. And leaves a little harder. 500rpm to be exact. (Which is nothing). Gains over a tenth. You can listen to a guy with an NHRA license or not. It’s up to you. But all your going to do. By making no changes. Other than videoing your runs. Is run the exact same times you already have. But you’ll have videos of runs. With no improvements. I promise you. At 30psi. Your spinning! Did you really do over 3 grand of modifying for half a tenth?
He's also on a stock tune in summer heat. I don't care what you say, he's not getting enough cold air and likely timing off the line to improve the 60' much further given the conditions. I've been to the track in similar conditions, with a drag setup, on a stock tune 3.15 auto car. I averaged 1.90s in the 60' with the stock tune in summer heat on 18psi.Hes on drag radials
My point was tires arent his limitation. When people reference poor 60s and street tires its a traction issue. I agree, his iat is probably through the roof.He's also on a stock tune in summer heat. I don't care what you say, he's not getting enough cold air and likely timing off the line to improve the 60' much further given the conditions. I've been to the track in similar conditions, with a drag setup, on a stock tune 3.15 auto car. I averaged 1.90s in the 60' with the stock tune in summer heat on 18psi.
OP, get an E-85 tune if its available. It'll ramp you up early enough to reach 7s.
Yeah the drag brakes and drag wheels should cut at least 0.3 seconds off his 60 ft. And on top of that a catback. Wow the sound alone should make get another 0.1. Any 40 hp VW beetle should spin drag radials with 30 psi. I swear I don't know what the problem is.You can’t spin a drag radial? Are you f$&king kidding? You guys see a 1.9 sixty? And your answer is. That’s normal? For a car on drag radials? With suspension mods and weight reduction???...The stupid shit you read in this section never ceases to amaze me! OP You should 1.7 sixty. With just an idle stomp on radials! Stall it up to 1500rpms. And 1.6s are doable! Just for shits and giggles. Try lowering the pressure in the tires. 10 or 15 psi. and report back. After your next trip to the strip.
1.6s are impossible! Are you running 30 psi?I've rarely gone to the track with this car I still think my 1.6 is terrible because it's not a super dead hook on MT S/S