PP Wheels

[mvic1518]

Does anybody know if the 2015 PP wheels would fit on a 2012 Boss 302?

Sponsored

 

[tevaburns]

I bet they would

 

[carguy]

Yes they will. I believe the regular BOSS oem wheels are the following spec:

19x9 et42
19x9.5 et 45

The GT PP wheels are:

19x9 et45
19x9.5 et52.5

So the front PP wheel would only sit inboard 3mm compared to OEM BOSS wheel and the rear would sit inboard 7.5mm compared to the BOSS rear. Pretty close. You have plenty of room in board to allow for that movement as well.

I have a set with less than 500 miles for sale.

 

[mvic1518]

The rear fit fine but the front wouldn't clear the brembo. They sure looked nice.

 

[Need4SpeedMotors]

The rear fit fine but the front wouldn't clear the brembo. They sure looked nice.

Was it because of the inner barrel clearance was not enough ?

 

[carguy]

The rear fit fine but the front wouldn't clear the brembo. They sure looked nice.

That's interesting. So I will assume that since the rotor is 1" smaller at 14", it's the 4 piston caliper from the Boss that is actually wider and protrudes out farther than the 6 piston from the GT PP and hits the spokes??

 

[ssyellow]

That's interesting. So I will assume that since the rotor is 1" smaller at 14", it's the 4 piston caliper from the Boss that is actually wider and protrudes out farther than the 6 piston from the GT PP and hits the spokes??

Correct, thats the consensus I have gotten from speaking with people. A local guy ran track pack wheels on his PP car and there was tons of clearance as a result.

Sponsored