PP Radiator Braces.

[jgedde]

This is part of the chassis stiffening used in the Performance Pack Mustangs. I needed to remove this to accommodate the Whipple Intercooler.

$30 shipped.

John

Sponsored

 

[yankee-carpet-bagger]

Sent a PM ref: a purchase offer

 

[CVCashmere]

Will These Fit a Non-PP Mustang?

Hi All

I never even knew that this part existed. Anyone know if you have to remove the radiator to put it on?

Would it fit a non-PP Mustang?

Anyone have a picture of one installed on their car so I can figure out some of the above questions?

thanks

CVCashmere

 

[jgedde]

SOLD.

 

[jgedde]

Hi All

I never even knew that this part existed. Anyone know if you have to remove the radiator to put it on?

Would it fit a non-PP Mustang?

Anyone have a picture of one installed on their car so I can figure out some of the above questions?

thanks

CVCashmere

Radiator does not need to be removed. The braces go between the front bumper and the radiator support behind the grill.

That said, if the radiator DID need to be removed, it's really easy to do on these cars.

John

 

[whatsup62]

Front fascia has to come off

 

[jgedde]

Front fascia has to come off

I'm not 100% sure that's true. There's a lot of room in front of the radiator to get your arms up into by removing just the belly pan...

Removing the front fascia isn't too bad to do except for two bolts up in the wheel wells where the bumper meets the fender. Those are a ROYAL PITA.

J

Sponsored