Jmeo
You said member ;)
- Joined
- May 28, 2014
- Threads
- 248
- Messages
- 8,333
- Reaction score
- 8,384
- Location
- Massachusetts
- First Name
- Jaime
- Vehicle(s)
- 2020 GT500, 2022 F150 PowerBoost
- Vehicle Showcase
- 2
- Thread starter
- #1
I am selling my anodized black LMT billet supercharger lid. There is an anodization blemish on the rear of lid where the NPT port is. I was assured by Jeff from LMT that it only a blemish and not a structural issue. The blemish is NOT visible when the lid is on the car, it is the back passenger side corner, which is sandwiched between engine and the firewall and the covered by the strut tower brace. It comes with the OEM factory snake top plate, which has a Bemaro Films snake decal installed.
These are $1,800 new without the snake plate so make out here at my loss and your gain at $1,200 shipped to your door.
These are $1,800 new without the snake plate so make out here at my loss and your gain at $1,200 shipped to your door.
Last edited:
. I dont need this, but i want it lol