Paxton Dyno results

[JohnG]

I attended an SVT and Performance Ford meet on 4/24 in Peoria, IL. They had a mobile dynojet out there, so figured it was a good time to throw the car on there to see what she makes. I did the Paxton install myself.

It made 619/484 hp/tq on the 1st pull.

Mods:
Paxton Novi 2200
3.6" pulley
ID1000's
JMS bap
Lund tuning

And that's pretty much it aside from an h-pipe that replaced the big ole resonator.

Pic of my car and my buddy's 2011 with a TVS.

HP and TQ on a different scale. Not sure what's going on with the TQ from 4500 to 5000 and then again at 6000

[ame]

Sponsored

 

[z06psi]

video is private

 

[whatsup62]

How much boost is that?

 

[zaquhree]

Is it pulling timing in those rpm ranges?

 

[JohnG]

video is private

Fixed

How much boost is that?

Not really sure. No boost gauge yet. Crowderb made 14 psi with this pulley. He had factory exhaust but was also using the CAI.

Is it pulling timing in those rpm ranges?

It's possible. I almost started a log before it went on there and now I wish I would have.

 

[zaquhree]

Fixed



Not really sure. No boost gauge yet. Crowderb made 14 psi with this pulley. He had factory exhaust but was also using the CAI.



It's possible. I almost started a log before it went on there and now I wish I would have.

Take a 3rd gear log to 6000 WOT and check SAOFT and KNOCKR to see if you're pulling timing where you lost power on the dyno

3.6 makes 10-13 psi depends where you let it rev up to

 

[JohnG]

Take a 3rd gear log to 6000 WOT and check SAOFT and KNOCKR to see if you're pulling timing where you lost power on the dyno

3.6 makes 10-13 psi depends where you let it rev up to

Ok. I will see if I can get out this evening to check that.

Sponsored