50BMG
Well-Known Member
- Thread starter
- #1
I believe this question applies to all the Coyote generations, but my personal experience is limited to Gen. 3 for the most part.
1). From my understanding, on a stock Coyote motor, the oil pressure sensor is located/tapped into the oil filter adaptor which is mounted on the front side of the block. Yes? No?
This would be the same whether the car is equipped with or without an oil cooler too, correct?
2). In relation to the filter, where in the stream of oil coming through the oil filter adaptor is the pressure read?
Is it on the inbound side of the filter or the outbound/post filter side of the flow?
Thanks ahead of time for any responses...
1). From my understanding, on a stock Coyote motor, the oil pressure sensor is located/tapped into the oil filter adaptor which is mounted on the front side of the block. Yes? No?
This would be the same whether the car is equipped with or without an oil cooler too, correct?
2). In relation to the filter, where in the stream of oil coming through the oil filter adaptor is the pressure read?
Is it on the inbound side of the filter or the outbound/post filter side of the flow?
Thanks ahead of time for any responses...
Sponsored
