nGauge configuration

[jimmydean]

I purchased an nGauge last week. When I try to copy my factory tune to the ngauge it does not show a 2018 mustang when asking to select vehicle type. It shows plenty of other Ford options but no 2018 mustang option. I would like to save the factory tune.
The firmware is the latest 262 but is date feb 2018. Lund has a 262 firmware dated 2/2018. Same firmware number different release dates though.

My car is a 2018 Mustang GT. The ngauge finds the car when hooked up to obd, reads gauges etc.
Looking for input ,will email Lund too. Also going to load in new firmware and remove old firmware.

Thanks in advance,
Jim

Sponsored

 

[stang1971]

lund will send you a stock file for your car so it speeds up the install time of the tune.


They sent me the flex fuel tune along with a stock 18 factory tune... no issues loading the tune.

 

[jimmydean]

'OK .Now I got it. Lund sent me a stock tune along with a JLT tune pump gas. I am supposed to load the JLT tune with the cai and datalog. I will send them the datalog and they will make me a flexfuel tune.

Figured I better save the Ford tune. Am currently downloadind it to 2018 f150 config, the only one that let me. Looks like I dont need this after all as the Lund stock tune is the same as Ford tune.

Thanks stang1971 for shedding the light.

Jim

 

[beefcake]

sounds like your all set!

Sponsored