Kenne Bell Boost A Pump

[H35]

Looking to hook up the Kenne Bell BAP tonight.

I know the module is under the back seat, I was just looking to see which wires get hooked up. Instructions only show up to 2014 which is in the trunk.

I looked on the internet and searched here but couldn't find the answer.

Thanks

Sponsored

 

[Reds197]

2015 has same color wires.

 

[H35]

So the purple with the green stripe gets cut, correct

 

[Travis@boostworks]

Yes.. Cut the purple with green strip. The end coming from the front goes into the fused red wire on the BAP. The other red wire coming out of the BAP goes to the other end of the purple/green stripe going into the FPDM. Ground it, mount it behind the plastic trim panel and you're done. There's a ground bolt behind the plastic panel that you can connect to, as well.

 

[H35]

Thank you both for your help

Rob

 

[proamas]

Yes.. Cut the purple with green strip. The end coming from the front goes into the fused red wire on the BAP. The other red wire coming out of the BAP goes to the other end of the purple/green stripe going into the FPDM. Ground it, mount it behind the plastic trim panel and you're done. There's a ground bolt behind the plastic panel that you can connect to, as well.

Travis where do you run the pressure switch wires through at in the firewall? Is there a specific spot for the switch to go on the SC?


Sent from my iPhone using Tapatalk

 

[Travis@boostworks]

I run it through a gromet where the factory sound tube used to be.

Sponsored