balance shaft delete?

[Tune+]

The massive one comes with instructions for a Focus ST not a ecoboost Mustang. I installed my STEEDA motor mounts yesterday and had a look at what I'll need to do to delete the BS with the engine in the car. Subframe will have to come down and oil pan will need to be removed (obviously).

Sponsored

 

[Edkiefer]

The massive one comes with instructions for a Focus ST not a ecoboost Mustang. I installed my STEEDA motor mounts yesterday and had a look at what I'll need to do to delete the BS with the engine in the car. Subframe will have to come down and oil pan will need to be removed (obviously).

So you don't think there room to just loosen motor mounts and raise engine as high as it goes (tranny hits tunnel ) to clear pan ?

I guess not to bad to remove/lower subframe other than rack is on it .

 

[Tune+]

So you don't think there room to just loosen motor mounts and raise engine as high as it goes (tranny hits tunnel ) to clear pan ?

I guess not to bad to remove/lower subframe other than rack is on it .

You will smash your HPFP before you hit the tunnel with the transmission.

 

[BGolden]

Plenty of room to lift the motor and pull the pan. I have done it several times.

 

[ELPYBOOST]

see post #3

Hey atleast it kept the ball rolling again.

 

[ThatsMrGimp2U]

So a big allure of the bsd, for me at least, is room for a windage tray to keep the sump area fed. The one that panda motorworks sells as a kit is actually for the FoST. Massive does not list anything other than the BSD for the mustang. According to Carl at massive, they are not compatible, and they don't make them for the mustang. So is the only windage tray option from FFTEC?

*Edit*

So FFTEC currently only makes the trays for in house built motors. A guy I spoke with earlier from there said he will see if thats something they can sell individually and get back with me.

Sponsored