jr16
Well-Known Member
- Joined
- Jun 8, 2021
- Threads
- 68
- Messages
- 140
- Reaction score
- 57
- Location
- South Florida
- Website
- www.lethalperformance.com
- First Name
- Joe
- Vehicle(s)
- 2012 CTS-V
- Thread starter
- #1
Hey All!
This is the all new Support Bash Bar w/Jacking Pad for the 2015 and UP Ford Mustang’s from Scotidi Race Development!
While these have been made popular in the world of drifting, these are a badass addition to just about any race car!
Not only does this bar strengthen the back of the car, it knocks off a couple pounds compared to the OE Bumper Support, and it Provides a perfectly positioned jacking point in the rear of the vehicle, allowing for rear tire changes and working on the rear of the car a breeze!
The bumper bar comes with removable Delrin pucks that cap the ends to prevent the bumper bar from catching on things or cutting through the bumper, all while providing a sleek finished look to the bumper bar.
There is NO cutting or removing components necessary to install this bumper bar, as it was intended to take the place of the stock bumper bar. It makes for a super clean and easy install, as well as flush fitment with the bottom of the car. (Tested on Mustang GT, V6, and Ecoboost Applications).
Check it out in the link here!
https://www.lethalperformance.com/s...-s550-mustang-rear-bash-bar-014-011-0390.html
Of course, if you have any questions, feel free to reach out with any one of us here at Lethal Performance!
This is the all new Support Bash Bar w/Jacking Pad for the 2015 and UP Ford Mustang’s from Scotidi Race Development!
While these have been made popular in the world of drifting, these are a badass addition to just about any race car!
Not only does this bar strengthen the back of the car, it knocks off a couple pounds compared to the OE Bumper Support, and it Provides a perfectly positioned jacking point in the rear of the vehicle, allowing for rear tire changes and working on the rear of the car a breeze!
The bumper bar comes with removable Delrin pucks that cap the ends to prevent the bumper bar from catching on things or cutting through the bumper, all while providing a sleek finished look to the bumper bar.
There is NO cutting or removing components necessary to install this bumper bar, as it was intended to take the place of the stock bumper bar. It makes for a super clean and easy install, as well as flush fitment with the bottom of the car. (Tested on Mustang GT, V6, and Ecoboost Applications).
Check it out in the link here!
https://www.lethalperformance.com/s...-s550-mustang-rear-bash-bar-014-011-0390.html
Of course, if you have any questions, feel free to reach out with any one of us here at Lethal Performance!
Sponsored