Front belly pan/splitter hardware

[foolwithtools]

Hey everyone,

When installing my front splitter, I noticed that two nuts to hold in the screws that go into the innermost parts of the outer splitter wings (for a non-R 2020 GT350) were missing. Do you guys know what the part number for the nut that this screw is supposed to go into? It is not W70596-S403 (shown as HN1 in the parts diagram https://parts.ford.com/shop/en/us/body/bumpers/deflector-stone-6579779-1), I bought those and saw that they don't fit.

Sponsored

 

[2JZFAN]

Pretty sure those are W708464-S450B and I believe they come in packs of 4x

From a whole thread about splitters with diagrams: (https://www.mustang6g.com/forums/th...derson-cf-cf-clone-replica-oe-is-junk.154167/)

 

[SmokinAces]

sure it’s a nut plate your looking for possibly this one.

 

[foolwithtools]

Pretty sure those are W708464-S450B and I believe they come in packs of 4x

From a whole thread about splitters with diagrams: (https://www.mustang6g.com/forums/th...derson-cf-cf-clone-replica-oe-is-junk.154167/)

sure it’s a nut plate your looking for possibly this one.

It's not part of the hardware that comes with the splitter. It was one of the parts that was supposed to come pre-installed on the belly pan

 

[2JZFAN]

It's not part of the hardware that comes with the splitter. It was one of the parts that was supposed to come pre-installed on the belly pan

https://www.oemfordpartsdirect.com/...elby-gt350r--5-2l-v8-gas/body--splash-shields

Sponsored