Hello everyone!
I am here asking for advice/experience, as I have seen many different takes on this issue. Lets get straight to the point:
I have my engine torn down to the long block (just block and rotating assembly) and purchased a good few upgrades just to extend my engines life for a few...
Seriously considering getting a gen3 coyote short block, but would be using my gen2 heads.
I know the head-bolts are different (11mm vs 12mm). I've heard I can just pickup any gen3 head stud kit and put my gen2 heads right on, is that true, and is it just any generic headbolt kit for a gen3...
Hello,
I was hoping those of you familiar with the Voodoo heads might be able to shed some light on this for me. I recently acquired a Flat Plane Voodoo Shortblock and I was trying to figure out which heads to top them with. I already have a set of Ported Boss heads and I was wondering if I...
Have a set of Gen 1 heads for sale. Will need to be rebuilt. Drivers side had a bad lifter so replaced with new Gen 2 heads. They will include valves,springs and cams. They will be in 2 box's that way 53 lbs each. I am willing to ship. Asking $1800 OBO
I'm selling all parts -- all new -- for a 408 small block Ford build, plus some tools and Fox Mustang chassis parts.
I bought all of these parts new in late 2002 to early 2003, had the block and crank machined at Arlington Machine Shop, assembled the rods and pistons, and then tried to assemble...