awdtsi
Well-Known Member
- Thread starter
- #1
Just wanted to post up a few pics of my new wheel setup I got from Paul at PK Auto Design. I'm very happy with the results. They look and fit great with no rubbing!
- Wheels are MRR M600 19x10 Front and 19x11.5 Rear
- Tires Are Nitto Invo 285/35R19 Front and 345/30R19 Rear
- Suspension is BMR SP089 Front and SP088 Rear. Note I don't have my forced induction on the car yet so the front is sitting a tad high. It should drop to about the same height as the rear once I get my twins mounted this winter.
Unfortunately it was dark when I got them mounted and then snowed so these are the only pics I have. I tried to brighten them up a bit so you can actually see the wheels.
- Wheels are MRR M600 19x10 Front and 19x11.5 Rear
- Tires Are Nitto Invo 285/35R19 Front and 345/30R19 Rear
- Suspension is BMR SP089 Front and SP088 Rear. Note I don't have my forced induction on the car yet so the front is sitting a tad high. It should drop to about the same height as the rear once I get my twins mounted this winter.
Unfortunately it was dark when I got them mounted and then snowed so these are the only pics I have. I tried to brighten them up a bit so you can actually see the wheels.
Sponsored
Last edited: