Search results

Anyone know how long it takes to reprogram a ECM?

I have a smaller pulley run high compression. I’m on E 85 though, but it easily reaches temperatures of 130 here. Maybe you have a bad MAF sensor

I’m roush charged live in the desert and have never had this problem

I’ll bash the tuner for you because it’s their fault. Go with wengerd.

I recently had a wheel hub go out and it messed up my wheel sensor so I had to perform a reset. I got around the emissions till 2028. I’m gonna go with wengerd tune ASAP.

Yeah did all the parameters of a drive cycle

Yeah VMP tuned it. They’re good for products but they’re tuning sucks and they’re tuning support sucks

I know this has been talked about a lot on here and I hear people saying different things. I have LTH with high flow cats. And people with similar setups have pass emissions with this setup and a good tune. Will E85 not run hot enough for the O2 to get up to proper heat levels. I also have...

Their new I replaced them all when I put long tubes. Thanks for your feedback. I’ll figure it out 😅

Yeah if I disconnect them, my engine light will turn on. Also my tune is VMP and they said they don’t turn off anything. 😵‍💫

VMP is garbage. Let’s just start there. Go with wengerd

What long tubes and cats do you have. My car is tuned by VMP and they said because I have long tubes with high flow cats from stainless works it most likely will not show those as ready I have extensions on the back and have had them since I put long tubes on because I didn’t want to codes. I...

A And no emissions issues?

Do you have long tubes?

would being on E85 be an issue?

I’m rocking 12:6 compression I wonder how much more ponies that would be

Right on well good luck hitting that number.

The one from VMP correct that’s the one I have

Nooo i’m replacing my factory resonator with the switch fire

No I checked that even looked down the pipe. I bought the switch fire. I’m going to take that thing apart just to see lol 😂