https://www.amazon.com/gp/aw/d/B0107LPEWK?psc=1&ref=ppx_pop_mob_b_asin_title
Works great as far as I can tell. Mine has been installed for a coupe months.
Don't worry about the ACM DTC. I have it too and I believe it is a fault created when I change codes because it is easily cleared. Even so, the presence doesn't seem to effect functionality.
As far as your theme colors, I notice some of your APIM codes are GT350R theme, but that should not...
The great thing about reprogramming the APIM with ForScan is that you can change the settings without using the AS-Built values. Simply select the option under the one that reads "As Built". Then look at the description and change what you need to. One tip: copy down the existing values so you...
The trim on mined does match and is working fine, except for the toggle for LC and exhaust mode. I am still trying to get them to work with the normal EcoBoost settings, but everything else works perfectly.
I have the GT350 console control panel and the switches look to be a similar material as the rest of the buttons on the panel; not chrome at all. Here's a picture of the original eBay listing. The only thing is, the labels are for the GT350 so instead of my normal switches, I have one labeled LC...
I have a 2020 APIM if you are interested. You do not need brackets because it mounts to the back of the screen. I also have the ACM brackets if that is what you meant.
Both ends were connected to a black 22 gauge wire. The one in the decklid is shown in the pic I posted. See the arrows. The shield cable is wrapped in electrical tape with duct tape at the black wire. When I took the duct tape off, the two were sodldered together.
Nope. Just behind the APIM and I didn't notice it until I was troubleshooting the unavailable camera and only then because I was pealing back the insulation.
If anyone is searching for an answer to this question, STOP. I figured it out. The solution, in case anyone else runs into this same situation is:
As I was troubleshooting, I thought to run a separate pare of wires from the camera to the screen, to rule out faulty wiring. As I was pealing back...
Afternoon Stangers,
I decided to go all out and install the 8" screen on mine since I could not find a pinout diagram for the 54-pin connector for the other most unpopular mod with the 4" screen.
Everything seems to work perfectly after following that very detailed OP with one exception. I...
Thanks for your reply.
My original ACM was malfunctioning badly even after I performed the software update from Ford, so I figured if I was going to have to swap it out, I may as well upgrade to HD/SAT/etc. Sync3 system.
I just didn't want the bigger screen; personal preference. No other...
Hey y'all,
My guess is no one here has tried this particular configuration, but I have a question.
I attempted to upgrade my 2016 base system with a 4.2" screen to a sync 3 with a 4.2" screen following the OP instructions.
There must be some differences in the pin-out from the original...
Anyone have a line on TE-2035334-1 connectors (I'm an idiot, I should have written terminals)? I have been trying to find some for a while now. Thanks for any help.