Search results

I honestly never watched it till recently when I was logging for knock. I noticed my LTFT before I added boostane was pretty low and then it went up after I added it. It did help get rid of my knock though and added timing so stuff works great. But if it's really not a big deal I'll just leave...

Hey all, I had a question for any of you that run boostane or any other octane booster in your car. I have a Single turbo on my 2019 5.0 and am currently tuned on pump gas but I add a can of boostane professional every other fill up or whenever I'm going to drive it aggressively. I've noticed...

Yeah I know. There's only 2 other guys I know that are also done and driving theirs already but one is also having issues with his fuel trims and the other one hasn't driven his enough since he's still installing parts on it. But yeah spacing out the widebands is a bad idea I'm going to replace...

I'm using the lower one that they made on the exhaust pipe. The one on the downpipe interferes with the wastegate

I'm on pump 93 and the o2 is pointing straight down. Mounted on the passenger side exhaust bung. Didn't use the DP one since the wastegate was in the way of it but On3 said they didn't use that one anyway

So I'm running the new On3 single turbo kit on my '19 5.0 and have put a little over 3k miles on it already. Since the single kit only runs one o2 sensor, So far I have gone through 2 o2 sensors these past 3k miles. Is it common to go through o2 sensors more often due to the turbo or did I just...

Hey man I know this is an old thread, but did you ever figure this out? I'm in the middle of a single turbo install and have to relocate the oil filter if I want to run a full exhaust

Hopefully someone can put what you just said to work and get us a solution soon. I don't expect it to be cheap though

Oh okay. You weren't ever able to find a wiring diagram for the 2019+?

From what I know, the "issue" is it throws those error messages for the hill assist not available, active exhaust(if equipped), lane assist(if equipped), magneride. Other than that i was told it runs fine with no issues and no CEL. But yeah I think all those error messages should be able to be...

What kind of wiring issues?

Both the output shift speed sensor and reverse switch locations are blocked off on the transmission case, it doesn't have either. Only the one plug which I'm assuming controls both of those and the rev matching features

Yeah I'm going to ask a tech I know at Ford if he can get me a diagram of the harness that runs to the trans. I'm hoping ford might of left some plugs hiding up somewhere incase someone was to swap the trans but I highly doubt it lol as for the rear end swap, I had considered it but I ended up...

Alright guys, so I know it's been done plenty of times on the 2018's where the factory MT82-D4 is swapped out for a 11-17 MT82 and everything is plug and play. But on the 2019 the MT82-D4 has changed from the 2018. It no longer has the 3 pin speed sensor and what im assuming is the reverse...