Search results

Update: Completely not any fault of VMPV hardware or software. I figured it out. Make sure you unplug your battery before the install and either zip tie or electrical tape the positive lead oh o the way. I uninstalled the positive terminal but at some point it flopped back over and was touching...

I did verify all the wires were connected and free of damage. There was no arcing that I am aware of during the install. So far have checked all of the fuses and they look good. What I am concerned about is that the “fuse” board outside of the fuse box with 3 terminals, 1 is the battery and 1 is...

So I went and added a VMP Odin supercharger to the Bullitt. Install was pretty smooth for the most part. Now that everything is installed and complete I’m having a “service charging system” warning come on my dash, my battery isn’t charging and the car is running very rough to the point it idles...

I’ve seen the videos and even one about how it’s made but I’ve never heard one on a vehicle in person. If your friend does it take a listen and let us know what you think.

I did an h pipe first on 2 of my S550 GTs and can tell you it just makes it slightly louder and gives it a deeper tone. Interior noise doesn’t increase much at all and very little if any drone. If you’re worried about drone I have friends that went with the corsa double H pipe from lethal...

Yes I got 0% and by all rights I think it was excluded. But in Honolulu the Ford dealership was remodeling and covid was happening so at the end of April they had 1 x on their sales board. We talked for all of 5 minutes before they ran my credit and came back asking what they could do to put me...

I got my 2019 Bullitt back in April of ‘20 when Ford was offering 0% because of covid. Best decision I’ve made so far. I put the Barton short throw with factory reverse lock out collar and the steeds clutch spring with perch mount the week I got it. I knew the shifter was soft and I like crisp...

I just left Honolulu the 12th of last month. I’m now at fort campbell in Kentucky. Probably should update my info on here. Was a great 4 years on the island though.

I honestly don’t know. I just finished the supercharger and fuel system last night. I have to install the kooks headers today and then send the data logs for a drive-able tune before I take it out to the dyno Friday or Saturday. I went with an 85mm pulley so about 15lbs of boost. I’ll have to...

33, 2019 Bullitt supercharged with VMP Odin

Had my ds center support bearing go out, or maybe it’s not quite done yet since it’s still ticking and not quite howling just yet. The Ford dealership here said it was just the bbq tick sound from the motor which resulted in me renting out a bay and lift to inspect myself. It’s definitely the...

I am also wondering this. Has anyone found it? Or any of the other fluid caps?