Search results

Selling Ford Racing lowing springs with performance pack shocks 9,000 kms on them $300

Selling brand new Mickey Thompson 28x11.5x17 $625

Still available

Brand new 800HP Mcleod RST twin disc clutch $620

Located in Vancouver but will ship Brand new 800HP Mcleod twin disc clutch $800 CDN

How is nitrous activation controlled when launching at the drag strip say for example a a window switch is set for 4500rpm-7800rpm but a msd 2 step is set a 5500rpm will nitrous be activated while clutch is in ? is there a way to control the gear it is activated ?

Hope this isn't a daily driver between the fumes and exhaust soot that will cover the side of you car.

nitto nto5r/nto5/nt55 G2 305/35/19 you can run a 305 on a 10" no problem

I had my ford racing X pipe crack as well

You can find better pricing than from ford performance website search around a bit

I purchased your hardware upgrade kit from a forum member a couple months ago, I had a feeling this was going to happen.... now time to install, or go through bolt route unsure yet.

Yes it was standard steeda hardware

Another sheared diff bolt

Just finished mine you will need: Manifold https://performanceparts.ford.com/part/M-9424-M50CJ Throttle body https://performanceparts.ford.com/part/M-9926-CJ65 Intake https://performanceparts.ford.com/part/M-9603-M50CJ Injectors https://performanceparts.ford.com/part/M-9593-LU47 I did not...

Is there a Steeda discount code available for the Canadian website?

Thanks that is what I was thinking I will go with that !

The problem is I do not know what goes where. And the ford performance instruction manuals don’t help much

I did not I was told it could be done without it.. seems like there are a lot of parts that would not be needed in that kit.

I’ve been trying to search but haven’t found many details on vaccum routing. I can not figure out vacuum lines for he life of me... I attached some pictures I have no idea what goes where. I should also mention I will be deleting pcv and using filters so I know some will have to be capped off...

looking for a 17" drag setup does anybody know if the below will fit the rear ? these are cobra R replicas : Wheel Size17x10.5Wheel Offset27Bolt Pattern5-114.3Hub Size70.6Back Spacing6.81