Search results

Where is the reluctor ring for the rear wheel? Is it embedded into the rear hub? I had my rear wheel all apart and noticed that I didn't see an obvious ring with teeth for the speed sensor to read.

I am looking for 18x9 wheels for my 2016 GT with a +12 offset. shopping for very specific non normal setups on websites is difficult and/or confusing. getting the size, offset, and correct bore into the search is seemingly the challenge. Also, not looking for anything high end. In fact, the...

anybody know of stainless lines that are longer than stock? I am having a hard time locating lines with those thread sizes?

need to replace my front shocks on my steeda coilover kit. Can I get the military coupon code?

I think the caliper banjo bolt is M10x1.5, but what is the connection at the chassis? I need to get longer brake lines for nonsensical reasons, and I am wondering if a lift kit brake line (longer) will work.

Is that flocking? I have some scratches in the plastic on my doors, and I have been looking for a simple way to hide them.

looks sharp. I have also purchased these floor mats. Did yours come with instructions for all the different tabs/clips? The only reason I haven't put mine in yet is because I want to make sure I get the clips in the right place.

do it yourself. I just did Steeda pro-action coilovers and rear shocks and struts. I did it on jacks in my parking lot. There is no joy like trying to get the rear springs out of their perches. F those B's

Correct To finish the day, I installed Steeda coilovers with 350 springs, Steeda pro-action rear shocks and springs, Steeda subframe bushings, and Steeda subframe alignment bushings. I put coins in the coin tray, cupholders, and door pockets. Definitely more vibrations under acceleration, but...

So, I installed the boomba 70D mount. I only had the steeda front and rear subrame braces, and no other IRS or mount upgrades. I had a small amount of added vibration. I cruised around holding the rpm at 500 intervals. I didn't feel any difference at specific rpms. I did a couple street...

I have this in my install pile along with upgraded engine mounts and engine supports, rear diff bushings, etc. Would you like me to install this alone, and see how it feels?

literally just tried cutting through the board just under the base model radio section. Tried to measure the resistance of the paths and add resistors in line where the circuit should be completed. The panel only partially came up and the rear defrost was stuck on. The car would start but the...

I had the base model and I also tried to modify the circuit board to ditch the upper half. Did not work.

nope

I wrapped it myself. Here is the new kit for the F-150. I am hoping a similar one comes out for the mustang.

The failure is from the scoche kits. I had 4 "brains" sent out and each one failed. I switched to the metra and have not had any problems. The only thing with the metra is the "gummy" buttons for the climate control. It also is touch screen. Supposedly metra is coming out with a better...

I went with the XS Power D1200, but if that ever turds out, then I might check out the 4700.

I have been hoping your coilovers would go on sale. Finally! I picked up the full pro-action setup with rear shock mounts. Can't wait.

In order to ship my corsa sport to apo, I had to first mail it to a friend in the states, who had each section cut up to meet shipping length restrictions. When they got to me, I had them welded back together. I put the exhaust on, by myself on jack stands. The only adjustment I had to make...

I used the Metra kit to install a kenwood unit and full JL amp/speaker/sub. Easy install, I lost the steering wheel controls for phone, but I never used it anyway. volume/track skip still work. I am actually waiting for their upgraded kit that doesn't use the gummy rubber buttons for the...