Search results

I'm running a staggered set up and had Mickey Thompson Street Comps 305/35/20 on the rear using Niche Targa wheels (20x10, 40 offset). I'm also lowered on BMR springs. I didn't have any noticeable rubbing issues before, but today I had identical sized Mickey Thompson ET Street SS installed in...

I hit a bump fairly hard today going around 30 mph and noticed my exhaust started sounding different. The pictures speak for themselves. The exhaust itself didn't hit anything that I'm aware of (there are no dents in the muffler). Apparently the jarring was enough to break the welds and just...

Recently I added a Sai Li fuel system and got an E85 tune for it. I made the switch from 93 and flashed the tune. I drove it a few miles and parked it in my driveway. The very next day, I began having low voltage warnings. The alternator was replaced under warranty, and everything seemed...

The hardware on my jackscrew has started to rust. It's likely due to the amount I run my car through a touch free car wash since I have no garage. I'm ordering replacement hardware, but I would very much like to find some kind of plug to go in the heat extractor so water can't get on the...

All of this OPG talk has made me paranoid, so I thought I would look into getting a quote to have it done. I also have a set of BMR springs I've been waiting to have installed, so I figured I'd go ahead with that as well. The quote I got comes from a local Ford dealership. Normally I'd be...

It took a bit longer on the install than I would have liked, but I'm a bit of a mechanical idiot. That said, the car runs and drives great, and nothing has blown up yet. Specs: 2016 GT premium, A6 3.55, MBRP race, Procharger Stage II P1SC, 95 lb DW injectors, canned tune. Dyno coming soon...

So I'm in the process of installing my Procharger stage 2 system. I've gotten the fuel rails off and swapped to the new included Deatschwerks 95lb injectors. After swapping the injectors out, the instructions say to remove the factory fuel rail spacers and install the newly supplied spacers...

I've found a handful of threads scattered around with pictures, but no thread dedicated solely to pictures of boost gauges and where to install them. My Procharger stage 2 kit should come in this week and I need to finally buckle down and figure out what boost gauge I want, and where I should...