Sponsored

Search results

Search the forum Search Articles

  1. Spec Clutches Question

    So i am thinking about getting the Spec Clutch 3+ with the billet steel flywheel. Does anyone have any experience with them?

  2. Paxton question

    Is there a power difference from running a filter directly on paxton compared to running the full cold air intake

  3. Anyone running different intake manifold with centri blower

    Just wondering if anyone is running different intake manifold with there centri blowers. Pros & Cons

  4. is anybody runnig a Paxton with edelbrock victor 2 intake manifold

    Just want to know if anybody runnig a Paxton with edelbrock victor 2 intake manifold? did you get any gains over stock intake?

  5. Paxton 2200sl to a vortech V7 YSI

    Need to know if i bought a V7 head unit will all my paxton piping work so i dont have to buy complet kit

  6. Anybody running a Paxton with 3.48 or 3.33 pulley

    I currently have a 3.6 pulley and a complete fuel system but want more boost. Looking to see if anyone is running a 3.48 or 3.33 pulley with stock motor with opg/cs. Looking to see any issues and power gains with either pullies.

  7. one piece driveshaft problem

    Has anyone had a problem with there one piece drive shaft makeing a metalic pop sound when reversing the going forword sometimes?

  8. Blow a hole in my muffler today

    Well looked under my for a rattling noise and noticed i blow a hole in my driverside muffler (borla ATAK). Has anybody seen this before?

  9. Has anybody done a wastegate setup on 2015 mustang with paxton

    Was wondering if anybody has done a wastegate setup on paxton supercharger on 2015 mustang? Does anybody sell a directfit kit? If so how is drivabilty?

  10. DSS 800 halfshaft install question? NEED HELP

    I have dss 800 halfshafts and dont know how to tell which side is which. One shaft looks a little different. Does it matter which side they go on?

  11. Paxton 2200sl stock blow off valve adjustment question?

    I have a paxton 2200 sl and i am thinking my stock blowoff and dont think it is shutting and building boost. I have and ecoboost vac/boost gauge on my gt and dont see it showing that i am getting any boost. Should i adust yhe blow off valve, and how?

  12. Charge motion control plate with paxton supercharger

    Has anybody disabled there charge motion control plates when putting on a centrifugal blower to see if can get any gains.

  13. Changing rear gear from 3.73 to 3.31 speedometer recalibration question

    I am changing my rear gear to 3.31 from 3.73 and am running lund tune. I need to recalibrate speedometer but lund said they dont have ability with there tune to change that because the program is in the BCM. How do i fix this and still run my lund tune?

  14. Fore innovation fuel system install help

    Has anybody installed the fore fuel system? Going to install myself and need any pointers and pics anybody has.


Top