Borg Warner EFR 7064 T3 Single scroll with custom 304 adaptor making it bolt on.
Turbosmart Wastegate and BOV upgrades.
3" VBand downpipe starter, slips into a 3" MRT downpipe perfectly, others may need modding.
2.5" 304 hot side pipe
3.5" intake tube to stock box
This is off and ready to...
SOLD!
Ford Racing M-5230-M4SC Borla Sport Axle Back Exhaust.
On my car for approx 10k miles, great condition, no dents no dings! Sound much better than stock! I used Nevr-Dull and gave them a quick 10 minute clean up, with some more elbow grease they could be near perfect. They sell for...
For anyone that installed a downpipe and wished they had wrapped it, well it is possible to do it on the car. I have an MRT catted DP and I was able to wrap from flange to cat while it was on the car. It was a PITA and involved dropping the roll a few times but it worked, started under the...
Anyone else experience this? The 3bar map sensor I purchased, CX 2231, aA5Z9F479B does not match up connector wise. Any input appreciated, I have the pigtail kit en route......
-Matt
2015 EBM PP.
SOLD!!!!!!!!!!
Had these made on Saturday at a local shop, so yes press bent, 409 stainless with 304 tips. I had them in the car for about 60 miles. Entirely too loud, but then I have an MRT catted DP full 3" to the custom resonator delete, then 2 1/2, then the stock rear 2 1/4. So these will...
Purchased these thinking I would need them, turns out I don't. First $20 gets them shipped to you. Remember, starting with 2015 lugs are a different pitch, 14x1.50, not the old 1/2-20 they were for years.....
SOLD!!!!!!!!!I bought these to try to get my stock 2014 18" base wheels for winter to clear my 2015 Ecoboost PP Brakes. I test fitted and they worked perfectly. Thinking they would work on the 2010-2014 brembo cars as well. Asking $35 shipped
So I decided to build my own intercooler pipes out of 304 stainless, I have about $50 in this project so far, bought a 180 degree 2.75" bend, cut it up as needed and welded it up. I didn't spend a lot of time polishing it because I'm going to either coat it or wrap it.
Ordered this gasket to start "reverse engineering" to build an T3/T4 adaptor, off to the local machine shop with my fancy cardboard template to have it cut out on the plasma table, not CNC, but gets it damn close. Both flanges will be 1/2" 304 and the transition tube will be schedule 10 304...
I purchased a CXRacing FMIC intended for the E90 BMW's and a few bends and couplers and made it work. Best mod ever and less than $300.
CxRacing FMIC core is 18x12x3.5
- 45 degree bends, one 2.75 and one 2.5
- 45 degree couplers, one 2.5 and one 2.5 to 2.75.
- map sensor bung from ATP...